Coolant Temperature Sensor - Remove and Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, PERJ1017, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
- Drain the level of the coolant below the coolant temperature sensor. Drain the coolant into a suitable container for storage or disposal.
- Disconnect the plug on wiring assembly (2) from the wiring harness.
- Remove coolant temperature sensor (1).
Show/hide table
Illustration 1 | g00518087 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install coolant temperature sensor (1). Tighten coolant temperature sensor (1) to a torque of
20 ± 3 N·m (15 ± 2 lb ft) . - Connect wire assembly (2) to the wiring harness.
- Fill the cooling system with coolant to the correct level. Refer to the Operation and Maintenance Manual for the correct procedure.
Show/hide table
Illustration 2 | g00518087 |
Caterpillar Information System:
3406C (PEEC III) Truck Engines Glossary of Electronic Control Terms
3406E Engine Speed/Timing Sensor - Remove and Install
3176C Engine Cooling System Coolant (DEAC) - Change
G3300 Engines Engine Air Cleaner Service Indicator - Inspect
3406E and 3456 Generator Set Engines Fan Drive - Install
3406E On-Highway Engine Fan Drive - Remove
3406E On-Highway Engine Fan Drive - Assemble
3304B and 3306B Engines for Caterpillar Built Machines Water Temperature Regulator - Remove and Install
3406E On-Highway Engine Fan Drive - Disassemble
G3300 Engines Cylinder Pressure - Measure/Record
3524B Engines for Off-Highway Trucks Too Much Valve Lash
3176C Engine Cylinder Liner
3406E On-Highway Engine Engine Oil Pressure Sensor - Remove and Install
3500 Spark Ignited Engines Engine Design
318B Excavator Machine System Specifications Track Roller (Single Flange)
G3300 Engines Ignition System Spark Plugs - Inspect/Replace
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers Engine Oil in Cooling System
G3500 Engines Camshaft
C-10 and C-12 Truck Engines Compression Brake
G3300 Engines Cooling System Coolant (DEAC) - Change
3176C and 3196 Industrial Engines Engine Oil Pressure Sensor - Remove and Install
3176C and 3196 Industrial Engines Speed/Timing Sensor - Remove and Install
3524B Engines for Off-Highway Trucks Fuel in Cooling System
3176C Engine Cooling System Coolant (ELC) - Change