Rocker Arm - Assemble
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install the O-ring seals in button (6) and button (4).
- Install the O-ring seals and the buttons on the valve rocker arms, as follows:
- Support valve rocker arm (7) in a vise with soft jaws.
- Position the O-ring seal and button (6) on the round end of adjustment screw (5).
- Use a soft hammer to seat button (6) on adjustment screw (5).
- Install the O-ring seals and the buttons on the unit injector rocker arms, as follows:
- Support unit injector rocker arms (2) in a vise with soft jaws.
- Put the O-ring seal and button (4) in position on the end of adjustment screw (1).
- Use a soft hammer to seat button (4) on adjustment screw (1).
- Repeat Steps 1 through 3 for the remainder of the rocker arm assemblies.
- Lubricate rocker shaft (3) with clean engine oil and install the assembled rocker arms on rocker shaft (3).
Show/hide table
Illustration 1 | g01028860 |
Note: Do not reuse the O-ring seals on the rocker arm adjustment screws if the buttons have been removed from the adjustment screws.
End By:
- Install the rocker arms and the rocker shaft. Refer to Disassembly and Assembly, "Rocker Arm and Shaft - Install".
Caterpillar Information System:
3306B Industrial Engine Turbocharger - Install
3406E On-Highway Engine Rocker Arm - Disassemble
3306B Industrial Engine Turbocharger - Remove
3176C and 3196 Engines For Caterpillar Built Machines Crankshaft - Install
3176C and 3196 Engines For Caterpillar Built Machines Crankshaft - Remove
3176C and 3196 Engines For Caterpillar Built Machines Crankshaft Main Bearings - Install
3114, 3116, and 3126 Industrial and Generator Set Engines Fuel System - Prime
3176C and 3196 Engines For Caterpillar Built Machines Crankshaft Main Bearings - Remove
C-18 Truck Engines Compression Brake - Inspect/Adjust/Replace
3114, 3116, and 3126 Industrial and Generator Set Engines Engine Crankcase Breather - Clean
3406E On-Highway Engine Fuel Filter Base - Remove and Install
3176C and 3196 Engines For Caterpillar Built Machines Pistons and Connecting Rods - Disassemble
3176C and 3196 Industrial Engines Cylinder Head - Remove
3406C Engines for Caterpillar Built Machines Flywheel
3524B Engines for Off-Highway Trucks Excessive White Smoke
3406E On-Highway Engine Inlet and Exhaust Valve Springs - Remove and Install
3406E On-Highway Engine Rocker Arm and Shaft - Install
3406E and 3456 Engines for Caterpillar Built Machines Rocker Arm and Shaft - Remove
3304B and 3306B Engines for Caterpillar Built Machines Turbocharger - Disassemble
C-12 Truck Engine Cylinder Liner
3524B Engines for Off-Highway Trucks Too Much Vibration
3304B and 3306B Engines for Caterpillar Built Machines Turbocharger - Assemble
3406E On-Highway Engine Housing (Front) - Remove
3406E On-Highway Engine Housing (Front) - Install