5130, 5130B and 5230 Excavators, 784B, 785B, 785C, 789B, 789C, 793B and 793C Off-Highway Truck/Tractors and 992G, 994 and 994D Wheel Loaders Vital Information Management System (VIMS) Caterpillar

This diagnostic code is recorded when the control reads the voltage of the +5 DCV sensor supply circuit as above normal or this circuit is shorted to a voltage source that is higher than +5 volts.

1. CHECK FOR THE CORRECT VOLTAGE AT THE INTERFACE MODULE

   1. Turn the disconnect switch and the key start switch to the ON position.

   2. Check the voltage at the connector of the interface module from contact 27 (sensor supply) to contact 2 (ground). Use the 7X-1710 Cable probes to measure the voltage. Do NOT disconnect the machine harness from the VIMS main module.

      Expected Results: The voltage is 5.0 ± 0.5 DCV.

      Results:

      • OK - Voltage is 5.0 ± 0.5 DCV. The sensor supply voltage is correct. Check the message center in order to verify that the same diagnostic code is present. If the diagnostic code is still present, the interface module has failed. Replace the module. Refer to the Testing and Adjusting, "Module - Replace" section. STOP.

      • NOT OK - Voltage is greater than 5.0 ± 0.5 DCV. The sensor supply voltage is NOT correct. Proceed to 2.

2. HARNESS CHECK FOR SHORT TO THE +BATTERY CIRCUIT

   1. The disconnect switch and the key start switch remain in the ON position.

   2. Disconnect the machine harness from the VIMS interface module.

   3. At the machine harness connector for the VIMS interface module, measure the voltage from connector contact 27 (sensor supply) to contact 2 (ground).

      Expected Results: The voltage is 0.0 ± 0.5 DCV.

      Results:

      • OK - Voltage is 0.0 ± 0.5 DCV. The voltage is correct. The VIMS interface module has failed. Replace the VIMS module. Refer to the Testing and Adjusting, "Module - Replace" section. STOP.

      • NOT OK - Voltage is NOT 0.0 ± 0.5 DCV. The harness has failed. The machine harness is shorted to +battery. Repair the machine harness or replace the machine harness. STOP.