Alternator and Regulator
Show/hide table
| |
| 图 1 | g02560056 |
Show/hide table
| 技术规格，用于 7G-7889 充电交流发电机总成 | |||
| 项目 | 数量 | 零件 | 技术规格说明 |
| - | - | - | 使用碳堆式 4C-4911 蓄电池负载测试仪加载测试蓄电池，获取最大交流发电机输出 |
| 1 | 1 | - | 拧紧交流发电机的安装螺栓之前，先拧紧螺栓。 |
| 拧紧至扭矩为 |
|||
| 2 | 1 | 187-2034 法兰螺母 | 拧紧至扭矩为 |
| 3 | - | 6V-8187 螺母 | (B+) 接线端。 拧紧至扭矩为 |
| 4 | - | - | (R) 接线端的峰值电压必须不低于 (B+) 接线端的输出电压。 |
| 5 | - | 030-9612 螺钉 | (B-) 接线端。 拧紧至扭矩为 |
| 6 | 1 | 3E-5451 电压调节器组件 | 电压设置不可调节。 |
| 允许电压范围为 13.7 到 14.3 V。 | |||
| - | - | - | 电压为 12 V。 |
| - | - | - | 电流为 60 安培。 |
| - | - | - | 极性为负极接地。 |
| - | - | - | 可朝顺时针或逆时针方向转动。 |
| - | - | - | 最大接通转速为 2000 rpm |
| - | - | |
|
| - | - | - | 5000 rpm 时的最小满载电流为 60 安培。 |
| - | - | - | 1500 rpm 时的最小满载电流为 22 安培。 |
| - | - | - | 输出电压为 14.0 ± 0.3 V。 |
Caterpillar Information System:
3306B Industrial Engine Alternator and Regulator
3408E and 3412E Engines for Caterpillar Built Machines Alternator and Regulator
3306B Industrial Engine Alternator and Regulator
3306B Industrial Engine Engine Oil Pump - Assemble
3406C (PEEC III) Truck Engine Accessory Drive
3306B Industrial Engine Fuel System Secondary Filter - Replace
3408E and 3412E Engines for Caterpillar Built Machines Alternator and Regulator
3176C Engine Engine Design
3406C (PEEC III) Truck Engine Belt Tightener
Electronic Modular Control Panel II+ (EMCP II+) Paralleling Mode
3306B Industrial Engine Engine Oil Pump - Disassemble
3306B Industrial Engine Engine Oil Pump - Install
3306B Industrial Engine Alternator and Regulator
3306B Industrial Engine Alternator and Regulator
3408E and 3412E Engines for Caterpillar Built Machines Alternator and Regulator
3406C Engines for Caterpillar Built Machines Fuel Filter (Primary)
3176C and 3196 Engines for Caterpillar Built Machines Valve Mechanism
3304B and 3306B Engines for Caterpillar Built Machines Connecting Rod Bearings - Remove
G3304 and G3306 Engines Seal Adapter (Front)
3406E On-Highway Engine Crankshaft Main Bearings - Remove
3304B and 3306B Engines for Caterpillar Built Machines Connecting Rod Bearings - Install
3306B Industrial Engine Crankshaft - Remove
3408E and 3412E Engines for Caterpillar Built Machines Fuel Filter Base
3114, 3116 and 3126 MUI Engine Governors Governor Identification - Introduction