5130, 5130B and 5230 Excavators, 784B, 785B, 785C, 789B, 789C, 793B and 793C Off-Highway Truck/Tractors and 992G, 994 and 994D Wheel Loaders Vital Information Management System (VIMS) Caterpillar

Numerous VIMS service operations can be initiated by the operator or a service technician. A unique service program code (SPC) is assigned to each of the service operations. The service program codes are entered through the VIMS keypad module. Entering the service program code starts the corresponding service operation. The service operations are listed in Table 1.

Table 1

VIMS Service Operations
Service Operation	Service Program Code	Service Program Code No.
Attachment Code - Configure	"ATTACH"	288224
Calibration Modes - Enter	"SERV"	7378
Data Logger - Reset	"DLRES"	35737
Data Logger - Start/Stop	"DLOG"	3564
Display Backlighting - Set	"BLT"	258
Display Contrast - Set	"CON"	266
Display Language - Set	"LA"	52
Display Units - Set	UN	86
Event - Configure (9.6X or later)	"ESET"(1)	3738
Events Acknowledged - Show	"EACK"	3225
Event List - Show	"ELIST"	35478
Event Recorder - Start	"EREC"	3732
Events Statistics - Show	"ESTAT"	37828
Lubrication Cycle Times - Set	"LUBSET"	582738
Lubrication Manual - Start	"LUBMAN"	582626
Machine Status - Show	"MSTAT"	67828
Odometer - Set	"ODO"(1)	636
Resettable Totals - Reset (LHEX/OHT)	"RESET"	73738
Resettable Totals - Show (LHEX/OHT)	"TOT"	868
Service Lamp - Reset	"SVCLIT"	782548
Service Lamp - Set (9.5X or later)	"SVCSET"(1)	782738
Snapshot Trigger- Configure (9.5X or later)	"ERSET"(1)	37738
System Self Test	"TEST"	8378
Truck Payload - Calibrate	"PAYCAL"(1)	729225
Truck Payload - Configure	"PAYCONF"(1)	7292663

(1)	The service tool is required to be connected and communicating with the machine before this SPC is active.

Each service program code is a unique number of one to ten digits that abbreviates this operation. The service program codes have a letter equivalent that describes the service operation. This letter equivalent makes remembering the service program code for each operation easier. The English letter equivalent for each service program code is shown in parentheses. The same service program codes are used regardless of the onboard language.

After entering the service program code on the keypad, this request will begin after the "OK" key is pressed. This command must be activated within five seconds of entering the last SPC character. The maximum delay that is allowed between the entry of the SPC characters is five seconds.