IT14G Integrated Toolcarrier and 914G Wheel Loader Power Train Caterpillar

Removal Procedure

Start By:

1. Connect the steering frame lock. Refer to Disassembly and assembly, "Steering Frame Lock - Separate and Connect" .

1. Park the machine on a flat, level surface. Lower the bucket to the ground. Engage the parking brake. Chock the wheels in order to keep the machine from rolling when the drive shaft is removed.

Show/hide table



Illustration 1	g00486161

2. Remove four bolts (1) and two straps (2) at the end of drive shaft (3) .

Show/hide table



Illustration 2	g00486164

3. Slide drive shaft (3) onto the splined end (4). Disconnect the drive shaft from rear yoke (5) and provide clearance for removal.

Show/hide table



Illustration 3	g00486165

4. Remove four bolts (6) and two straps (7) that hold the drive shaft to front yoke (8) .

5. Remove the drive shaft from the machine. The weight of the drive shaft is 18 kg (40 lb).

Installation Procedure

Show/hide table



Illustration 4	g00486165

1. Install the drive shaft to the front yoke (8) with two straps (7) and four bolts (6). The Weight of the shaft is 18 kg (40 lb).

Show/hide table



Illustration 5	g00486164

2. Install cast end (3) of the drive shaft to the rear yoke (5) .

Show/hide table



Illustration 6	g00486161

3. Install two straps (2) and four bolts (1) at the cast end of drive shaft (3). Tighten the bolts to a torque of 70 ± 15 N·m (52 ± 11 lb ft).

End By: Connect steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".