Belt Tensioner
Show/hide table
Illustration 1 | g00390952 |
To adjust the belt, use the following procedure.
(1) Remove the tension from the belt.
(2) Align the thick black line on 134-1018 Film (1) with the shoulder (2) of tensioner's arm (3).
(3) Install the belt. The shoulder (2) should be in the green zone of the 134-1018 Film (1).
Caterpillar Information System:
3306B Industrial Engine Piston Cooling Jets - Remove and Install
3408E and 3412E Engines for Caterpillar Built Machines Bearing Clearance - Check
3304B and 3306B Engines for Caterpillar Built Machines Water Pump - Assemble
3304B and 3306B Engines for Caterpillar Built Machines Water Pump - Disassemble
3306C Truck Engine Water Pump - Install
3306C Truck Engine Water Pump - Remove
3406E, C-10, C-12, C-15, C-16 Truck Engines Engine Oil and Filter - Change
3306C Truck Engine Water Temperature Regulator - Remove and Install
3306C Truck Engine Exhaust Manifold - Remove and Install
3406E, C-10 and C-12 Truck Engines Belt Tensioner - Inspect
G3612 and G3616 Engines Engine Design
3306C Truck Engine Turbocharger Wastegate - Remove and Install
3306C Truck Engine Crankshaft - Remove
3306C Truck Engine Crankshaft - Install
3176C and 3196 Engines for Caterpillar Built Machines Engine Oil Filter Base
G3612 and G3616 Engines Air Starting System
G3606 and G3608 Engines Lubrication System
Electronic Modular Control Panel II (EMCP II) for EUI Engines Component Location
Electronic Modular Control Panel II (EMCP II) for EUI Engines EMCP Electronic Control (Generator Set)
C-10 and C-12 Truck Engines Air Inlet and Exhaust System
3406E, C-10 and C-12 Truck Engines Electronic Unit Injector - Inspect/Adjust
3406E, C-10, C-12, C-15, C-16 Truck Engines Fuel System - Prime
3176C and 3196 Industrial Engines Cylinder Head
G3606 and G3608 Engines Basic Block