Piston Cooling Jets - Remove and Install
Removal Procedure
Start By:
- Remove the crankshaft. Refer to Disassembly and Assembly, "Crankshaft - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Use a soft punch in order to remove piston cooling jet (1) from the cylinder block.
Show/hide table
Illustration 1 | g00473474 |
Installation Procedure
Show/hide table
Required Tools     | |||
---|---|---|---|
Tool     | Part Number     | Part Description     | Qty     |
A     | 6V-7772     | Driver     | 1     |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Note: The No. 2 and No. 6 bosses for the main bearings have two jets. The No. 3 and No. 5 bosses for the main bearings have one jet. A replacement is necessary only if the jets are damaged. Normally, it will only be necessary to ensure that the jets are clean.
- Use Tool (A) in order to install piston cooling jet (1) with the small end first. Install the jets in the bosses for the main bearing until the jets are against the counterbore.
Show/hide table
Illustration 2 | g00473474 |
- Ensure that the passage is open after piston cooling jet (1) is installed.
End By: Install the crankshaft. Refer to Disassembly and Assembly, "Crankshaft - Install".
Caterpillar Information System:
3408E and 3412E Engines for Caterpillar Built Machines Bearing Clearance - Check
3304B and 3306B Engines for Caterpillar Built Machines Water Pump - Assemble
3304B and 3306B Engines for Caterpillar Built Machines Water Pump - Disassemble
3306C Truck Engine Water Pump - Install
3306C Truck Engine Water Pump - Remove
3406E, C-10, C-12, C-15, C-16 Truck Engines Engine Oil and Filter - Change
3306C Truck Engine Water Temperature Regulator - Remove and Install
3306C Truck Engine Exhaust Manifold - Remove and Install
3406E, C-10 and C-12 Truck Engines Belt Tensioner - Inspect
G3612 and G3616 Engines Engine Design
3306C Truck Engine Turbocharger Wastegate - Remove and Install
G3612 and G3616 Engines Engine Design
3176C and 3196 Industrial Engines Belt Tensioner
3306C Truck Engine Crankshaft - Remove
3306C Truck Engine Crankshaft - Install
3176C and 3196 Engines for Caterpillar Built Machines Engine Oil Filter Base
G3612 and G3616 Engines Air Starting System
G3606 and G3608 Engines Lubrication System
Electronic Modular Control Panel II (EMCP II) for EUI Engines Component Location
Electronic Modular Control Panel II (EMCP II) for EUI Engines EMCP Electronic Control (Generator Set)
C-10 and C-12 Truck Engines Air Inlet and Exhaust System
3406E, C-10 and C-12 Truck Engines Electronic Unit Injector - Inspect/Adjust
3406E, C-10, C-12, C-15, C-16 Truck Engines Fuel System - Prime
3176C and 3196 Industrial Engines Cylinder Head