Install the Refrigerant Evaporator Coil
 |
Personal injury can result from air conditioning system pressure. The air conditioning system will become a pressure system when charged. To avoid personal injury see the Air Conditioning and Heating Service Manual for instructions on charging the system. Personal injury or death can result from inhaling refrigerant through a lit cigarette. Inhaling air conditioner refrigerant gas through a lit cigarette or other smoking method or inhaling fumes released from a flame contacting air conditioner refrigerant gas, can cause bodily harm or death. Do not smoke when servicing air conditioners or wherever refrigerant gas may be present. |
 |
|
Personal injury or death can result when charging an air conditioning system with a liquid. The compressor will pump the refrigerant back into the charging cylinder with the possibility of rupturing (exploding) the cylinder. Do not operate the engine when charging with a liquid. Never charge liquid or gas through the discharge (high side of the system) with the engine running. Keep all other personnel either away from the machine or where they can be seen when working on the air conditioning system. |
|
- Install evaporator coil (19) and two bolts (18) .
 | |
| Illustration 1 | g00470969 |
- Install air conditioning lines (12) and (13) .
- Install the blower and evaporator coil assembly.
- Tighten hose clamps (16) and (17). Open the water valves at the engine.
 | |
| Illustration 2 | g00470968 |
- Install eight bolts, the eight washers and cover (15) .
 | |
| Illustration 3 | g00470967 |
- Install housing assembly (14) .
 | |
| Illustration 4 | g00470966 |
- Connect air conditioning lines (12) and (13) .
 | |
| Illustration 5 | g00470958 |
- Install four bolts (11) and the four washers.
 | |
| Illustration 6 | g00470957 |
- Install two bolts (9), the two washers and bracket (10). Repeat for the other side.
 | |
| Illustration 7 | g00470956 |
- Install three bolts (5), the three washers and cover (8) .
 | |
| Illustration 8 | g00470905 |
- Install cable clamp (6) .
- Install the cotter pin (7) onto the heater control valve.
- Connect wiring harness (3) and two wire connections (4) .
- Install ten bolts, the ten washers and cover (2) .
 | |
| Illustration 9 | g00470372 |
- Install seven screws and panel (1) behind the seat.
 | |
| Illustration 10 | g00470371 |
- Charge the air conditioning system.
End By: Install the seat.