Engine Air Filter Secondary Element - Replace
Show/hide table
| NOTICE |
|---|
Always replace the secondary filter element. Never attempt to reuse it by cleaning. The secondary filter element should be replaced at the time the primary element is serviced for the third time. The secondary filter element should also be replaced if the yellow piston in the filter element indicator enters the red zone after installation of a clean primary element, or if the exhaust smoke is still black. |
- Open the engine access door on the back side of the machine. Use the prop rod to hold the engine access door open.
Show/hide table
 | |
| Illustration 1 | g00387726 |
Show/hide table
 | |
| Illustration 2 | g00448380 |
- Remove the air cleaner housing cover (1) .
Show/hide table
 | |
| Illustration 3 | g00101864 |
- Remove the primary filter element (2) from the air cleaner housing.
- Remove the secondary filter element.
Show/hide table
 | |
| Illustration 4 | g00038606 |
- Cover the air inlet opening. Clean the inside of the air cleaner housing.
Show/hide table
 | |
| Illustration 5 | g00101865 |
- Inspect the gasket between the air inlet pipe and the air cleaner housing. Replace the gasket if the gasket is damaged.
- Uncover the air inlet opening. Install a new secondary element.
- Install the primary element and the air cleaner housing cover. Fasten the clips in order to secure the air cleaner housing cover. The cover may need to be rotated slightly in order to allow the clips to clear the firewall.
- Reset the filter element indicator.
Show/hide table
 | |
| Illustration 6 | g00394918 |
- Close the engine access door.
Caterpillar Information System:
IT14G Integrated Toolcarrier Drive Shaft Universal Joints - Lubricate
793B Off-Highway Truck Power Train Torque Converter Lockup Clutch Leakage - Test
D250E Series II, D300E Series II, D350E Series II and D400E Series II Articulated Trucks Power Train Electronic Control System Switches
Challenger 65E, Challenger 75E, Challenger 85E and Challenger 95E Agricultural Tractors Air Conditioner Desiccant Receiver/Dryer - Replace
CP-563C and CS-563C Vibratory Compactors Crankshaft Vibration Damper - Inspect
793B Off-Highway Truck Power Train Torque Converter Lockup Clutch Pilot Pressure - Test and Adjust
IT14G Integrated Toolcarrier Cooling System Water Temperature Regulator - Clean/Replace
572R Pipelayer Digital Display Window
789B Off-Highway Truck Power Train Torque Converter Lockup Clutch Supply Pressure - Test and Adjust
IT14G Integrated Toolcarrier Cooling System Level - Check
3034 Engine for Caterpillar Built Machines Electric Starting Motor
572R Pipelayer Gauges
3406E and 3456 Industrial Engines Exhaust Manifold
IT14G Integrated Toolcarrier Engine Air Filter Service Indicator - Inspect
572R Pipelayer Light Switches
IT14G Integrated Toolcarrier Engine Crankcase Breather - Clean
IT14G Integrated Toolcarrier Engine Oil Level - Check
572R Pipelayer Horn
793B Off-Highway Truck Power Train Torque Converter Lockup Clutch Signal Pressure - Test
IT14G Integrated Toolcarrier Engine Oil and Filter - Change
Challenger 35, Challenger 45 and Challenger 55 Agricultural Tractors Power Train Oil Distribution To Clutch
572R Pipelayer Battery Disconnect Switch
914G Wheel Loader Equipment Lowering with Engine Stopped
IT14G Integrated Toolcarrier Fuel System Primary Filter - Replace