IT14G Integrated Toolcarrier Caterpillar


Cooling System Coolant Additive (DEAC) - Add

Usage:

IT14G 1WN

------ WARNING! ------

Pressurized system: Hot coolant can cause serious burn. To open cap, stop engine, wait until radiator is cool. Then loosen cap slowly to relieve the pressure.

----------------------

Note: This procedure pertains to Caterpillar Diesel Engine Antifreeze/Coolant (DEAC) only. This procedure does not pertain to machines that are shipped from the factory with Extended Life Coolant (ELC) and machines that are maintained with Extended Life Coolant (ELC).

See Operation and Maintenance Manual, "Cooling System Specification" for all cooling system requirements.

Use 8T-5296 Coolant Test Kit in order to check the concentration.


NOTICE

Excessive additive (greater than the recommended 6% initial fill) together with concentrations of antifreeze greater than 60% cause deposits to form and can result in radiator tube blockage and overheating.


Liquid Supplemental Coolant Additive




Illustration 1g00387726



Illustration 2g00448380

  1. Open the engine access door on the back side of the machine. Use the prop rod to hold the engine access door open.



    Illustration 3g00392877

  1. Slowly loosen the radiator cap in order to relieve system pressure. Remove the radiator cap.

  1. If necessary, drain enough coolant from the radiator in order to allow the addition of the liquid coolant additive.

  1. Add 0.24 Liters (.50 pint) of cooling system additive for every 38 Liters (10 US Gallons) of engine cooling capacity.



    Illustration 4g00392879

  1. Maintain the coolant level between the "FULL" and "ADD" marks on the coolant overflow reservoir.

  1. Install the radiator cap. Close the engine access door.

Caterpillar Information System:

572R Pipelayer Power Train Bevel and Transfer Gears
IT14G Integrated Toolcarrier Cooling System Coolant (DEAC) - Change
CP-563C and CS-563C Vibratory Compactors Axle Oil Sample - Obtain
CP-563D, CS-563D, CS-573D and CS-583D Vibratory Compactors Auxiliary Hydraulic System Steering Pump and Mounting
572R Pipelayer Power Train Transmission Mounting
IT14G Integrated Toolcarrier Cab Air Filter - Clean/Replace
572R Pipelayer Power Train Drive Shaft
793B Off-Highway Truck Transmission Tank Suction Screen - Clean/Inspect/Replace
IT14G Integrated Toolcarrier Battery, Battery Cable or Battery Disconnect Switch - Replace
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Alternator and Regulator
572R Pipelayer Caterpillar Monitoring System
Challenger 35, Challenger 45 and Challenger 55 Agricultural Tractors Power Train Transmission
CP-563C and CS-563C Vibratory Compactors Cooling System Pressure Cap - Clean/Replace
IT14G Integrated Toolcarrier Circuit Breakers and Fuses - Reset/Replace
3406E and 3456 Industrial Engines Vibration Damper
CP-563C and CS-563C Vibratory Compactors Cooling System Water Temperature Regulator - Replace
572R Pipelayer Gauges
3034 Engine for Caterpillar Built Machines Electric Starting Motor
IT14G Integrated Toolcarrier Cooling System Level - Check
789B Off-Highway Truck Power Train Torque Converter Lockup Clutch Supply Pressure - Test and Adjust
572R Pipelayer Digital Display Window
IT14G Integrated Toolcarrier Cooling System Water Temperature Regulator - Clean/Replace
793B Off-Highway Truck Power Train Torque Converter Lockup Clutch Pilot Pressure - Test and Adjust
CP-563C and CS-563C Vibratory Compactors Crankshaft Vibration Damper - Inspect
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.