Pump Control (Negative Flow) - Adjust
Show/hide table
Illustration 1 | g00363732 |
Pump compartment (27) Setscrew (28) Locknut (29) Setscrew (30) Locknut |
Note: Use the same procedure for both pumps. Use locknut (28) and setscrew (27) for the upper pump adjustment. Use locknut (30) and setscrew (29) for the lower pump adjustment.
- In order to adjust the upper pump, loosen locknut (28) .
- Turn setscrew (27) until the negative flow rate is adjusted to the correct specification.
Note: A clockwise adjustment of setscrew (27) and setscrew (29) decreases the flow rate. A counterclockwise adjustment increases the flow rate. A quarter turn of setscrew (27) and setscrew (29) will change the flow rate approximately 2.5 L/min (0.7 US gpm) at a system pressure of 2490 kPa (360 psi).
- Tighten locknut (28) to a torque of 12 ± 3 N·m (9 ± 2 lb ft).
- Adjust the lower pump. Use locknut (30) and setscrew (29) instead of locknut (28) and setscrew (27) to adjust the lower pump.
Caterpillar Information System:
315B Excavator Machine Systems Boom - Install
M322C Wheeled Excavator Machine System Swing Gear and Bearing
M315 Excavator Machine System Stick - 1.7 m (5.58 ft)
M318 and M320 Excavators Machine System Specifications Travel Motor
Installation of the Two-Way Pilot Valve (Control Pattern Change) {5059, 5496} Installation of the Two-Way Pilot Valve (Control Pattern Change) {5059, 5496}
330B Excavator Hydraulic System Relief Valve (Main) - Test and Adjust
315B Excavator Machine Systems Swing Drive - Disassemble
315B and 315B L Excavator Supplement For 3046 Engine Hydraulic System Pressure - Release
317B L and 317B LN Excavators Excavator Systems Swing Drive - Remove and Install
330B Excavator Hydraulic System Relief Valve (Pilot) - Test and Adjust
315B and 315B L Excavator Supplement For 3046 Engine Hydraulic Oil Cooler - Remove
315B Excavator Machine Systems Boom - Remove
M318 and M320 Excavators Machine System Specifications Control Valve (Boom Lowering)
315B Excavator Machine Systems Counterweight - Remove and Install
315B Excavator Machine Systems Fuel Tank - Remove
315B Excavator Machine Systems Swing Drive - Assemble
315B and 315B L Excavator Supplement For 3046 Engine Hydraulic Oil Cooler - Install
320B, 320B L and 320B N Excavators Work Tool Flow Control - If Equipped
M315 Excavator Machine System Stick - 2.1 m (6.89 ft)
M315 Excavator Machine System Stick - 2.4 m (7.87 ft)
M315 Excavator Machine System Stick - 2.6 m (8.53 ft)
M315 Excavator Machine System Stick - 3.1 m (10.17 ft)
5130B Excavator Hydraulic System Relief Valve (Margin)
315B Excavator Machine Systems Undercarriage Frame - Remove