Governor Control Linkage
Show/hide table
 | |
| Illustration 1 | g00299839 |
Show/hide table
 | |
| Illustration 2 | g00299838 |
Ensure that the governor shaft is in the low idle position. Then assemble the lever group, as shown.
(A) ... 5 degrees
(B) ... 90 degrees
(C) ... 45 degrees
(D) ... 10 degrees
Caterpillar Information System:
3306C Truck Engine Governor Control Lever
G3612 and G3616 Engines Overhaul (Top End)
3408C, 3412, 3412C, and 3412D High Performance Marine Engines Electrical System
Electronic Modular Control Panel II (EMCP II) For MUI Engines Normal Mode
3054 Engine Cooling System
G3612 and G3616 Engines Overhaul (In-Frame)
3500B High Displacement Turbocharger
3406E Truck Engines Air Inlet And Exhaust System
3406E Truck Engine Alternator and Regulator
3406E Truck Engine Engine Support (Front)
3412C Generator Sets Overspeed
3406E Truck Engine Water Lines
G3612 and G3616 Engines Overhaul (Major)
Instruction For Increasing The Horsepower Rating On The 3406B Truck Engines And The 3406C Truck Engines{1901} Instruction For Increasing The Horsepower Rating On The 3406B Truck Engines And The 3406C Truck Engines{1901}
3306B Industrial Engine Fuel Transfer Pump
3508, 3512 and 3516 Engines Engine Design
3508, 3512 and 3516 Engines Engine Design
3508, 3512 and 3516 Engines Engine Design
3406E Truck Engines Cooling System
3508, 3512 and 3516 Engines Crankshaft Position for Unit Injector Adjustment and Valve Lash Setting
3406E and 3456 Engines for Caterpillar Built Machines Compression Brake
G3606 and G3608 Engines Driven Equipment - Check
3406E Truck Engines Electrical System
3054 Engine Rocker Shaft