Illustration 1 | g00295928 |
Starting Motor (Side View) |
Illustration 2 | g00295930 |
End view of the starting motor which shows the electrical connections |
No load conditions at
- Rpm of shaft ... 7000 minimum
- Current draw ... 130 amperes maximum
- Voltage ... 11.5 volts
- Rated voltage ... 12 volts
- Current draw ... 130 amperes maximum
(1) Tighten the battery terminal nut to the following torque: ...
(2) Tighten the nut for the switch terminal to the following torque: ...
Tension of the spring for the motor brush ...
Minimum resistance of the starter cable at
Illustration 3 | g00731492 |
Voltage ... 12 VDC
Resistance between "W1" terminal and "W2" terminal ... 15 ± 1.5 ohms
Illustration 4 | g00295932 |
Voltage ... 6 VDC
Resistance between terminal "A" and terminal "B" ... 30 to 34 ohms
No load conditions at
- Rpm of shaft ... 7000 minimum
- Current draw ... 85 amperes maximum
- Voltage ... 23 volts
- Rated voltage ... 24 volts
- Current draw ... 85 amperes maximum
Minimum pull-in voltage ... 18 volts
Brush length:
- Minimum brush length ...
15.5 mm (0.61 inch)
Armature end play ...
Install shims or remove shims in order to adjust the armature end play to the correct specification.
Commutator
- New diameter ...
45 mm (1.77 inch) - Minimum diameter ...
42.5 mm (1.67 inch) - Minimum diameter ...