Track Carrier Roller
Show/hide table
图 1 | g01560845 |
(1) 安装时,橡胶曲面密封和所有接触面必须清洁干燥。 组装前,在金属密封圈的接触面上涂抹一薄层 6V-4876 润滑剂 。 金属密封圈必须装配成方形。 橡胶曲面密封不能凸起也不能扭歪。
(A) 端隙:
- 最低 ... 0.20 mm (0.008 in)
- 最高 ... 0.75 mm (0.030 in)
(2) 在密封的地方,用润滑剂将 O 形密封圈孔稍加润滑。
(B) 组装前,履带支重轮轴组件必须除去油漆的长度 ... 55 ± 5 mm (2.2 ± 0.2 in)
Caterpillar Information System:
G3612 and G3616 Engines Engine Crankcase Breather - Clean
3126B Engine for Caterpillar Built Machines Inlet Air Temperature Sensor
3126B Engine for Caterpillar Built Machines Atmospheric Pressure Sensor - If Equipped
3126B and 3126E Truck Engines Boost Pressure Sensor
3126B Engine for Caterpillar Built Machines Engine Oil Pressure Sensor - If Equipped
3408E and 3412E Engines for Caterpillar Built Machines Coolant Temperature Sensor
3512 Industrial Engine Cooling System Coolant Analysis (Level II) - Obtain
3054 Engine Water Temperature Regulator
G3606 and G3608 Engines Cooling System Level Switch - Inspect
G3612 and G3616 Engines Actuator Control Linkage - Lubricate - If applicable
322B Excavator Hydraulic System Visual Inspection
3408C, 3412, 3412C, and 3412D High Performance Marine Engines Cold Start Strategy
3126B and 3126E Truck Engines Belt Tensioner
3500 Generator Set Engines Cylinder Head
G3300 Engines Walk-Around Inspection
3512 and 3516 EUI Engines and 784B, 785B, 789B and 793B Off-Highway Truck/Tractors Valve Mechanism
3500 Generator Set Engines Fuel Injector Mechanism
3054 Engine Engine Oil Pan
3054 Engine Engine Oil Pump
C-9 Engines for Caterpillar Built Machines Injection Actuation Pressure Sensor
3126B Truck Engine Engine Oil Temperature Sensor - If Equipped
3054 Engine Engine Oil Pressure
3500 Engines for Caterpillar Built Generator Sets Fuel Injection Control Linkage
3500 Generator Set Engines Alternator and Regulator