Tachometer Drive
Usage:
Remove And Install Tachometer Drive
1. Remove bolts (1) and the clamps that hold adapter assembly (2) in position.
2. Remove the adapter assembly and coupling from the governor housing.
3. Remove coupling (3) and O-ring seal (4) from adapter assembly (2).
NOTE: The following steps are for installation of the tachometer drive.
4. Inspect the parts for wear or damage. Make a replacement if necessary.
5. Install O-ring seal (4) and coupling (3) on adapter assembly (2).
6. Install the adapter assembly in the governor housing.
NOTE: Make sure that the coupling engages with the shaft of the governor.
7. Fasten the adapter assembly to the governor housing with bolts (1) and the clamps.
Caterpillar Information System:
3406B DIESEL TRUCK ENGINE Electric Starting Motor
3406B DIESEL TRUCK ENGINE Fuel Injection Line Adapters
3406B DIESEL TRUCK ENGINE Fuel Injection Lines
3406B DIESEL TRUCK ENGINE Air Compressor
3406B DIESEL TRUCK ENGINE Conversion Chart (Inches To MM)
3406B DIESEL TRUCK ENGINE Seals (Hydrodynamic)
3406B DIESEL TRUCK ENGINE Seals (Lip-Type)
3406B DIESEL TRUCK ENGINE Batteries
3406B DIESEL TRUCK ENGINE Gaskets
3406B DIESEL TRUCK ENGINE Bearings
3406B DIESEL TRUCK ENGINE Shims
3406B DIESEL TRUCK ENGINE Rust Preventive Compound
3406B DIESEL TRUCK ENGINE Fuel Priming Pump
3406B DIESEL TRUCK ENGINE Fuel Filter And Base
3406B DIESEL TRUCK ENGINE Fuel Transfer Pump
3406B DIESEL TRUCK ENGINE Fuel Ratio Control For Use With Earlier Engines
3406B DIESEL TRUCK ENGINE Fuel Ratio Control For Use With Later Engines
3406B DIESEL TRUCK ENGINE Automatic Timing Advance 7FB1-Up, 4MG1-4MG3599
3406B DIESEL TRUCK ENGINE Fuel Injection Pump Housing And Governor
3406B DIESEL TRUCK ENGINE Governor
3406B DIESEL TRUCK ENGINE Fuel Injection Pumps
3406B DIESEL TRUCK ENGINE Fuel Injection Pump Housing
3406B DIESEL TRUCK ENGINE Turbocharger (TV72 & TV78)
3406B DIESEL TRUCK ENGINE Turbocharger (S4A)