Usage:
NOTE: Later fuel injection nozzles are installed in adapters that are above the surface of the cylinder head. The pictures to follow show the rocker arm shaft removed. This was for better photo illustration. It is not necessary to remove the rocker arm shaft.
Start By:
a. remove valve covers
1. Use Tool (A) to disconnect fuel injection line (1) at both ends. Remove the fuel injection line from the engine.
2. Use Tool (B) to remove retainer (2) from the adapter.
3. Remove the fuel injection nozzles with Tooling (C) as follows:
4. Remove compression seal (4) and carbon dam seal (8) from fuel injection nozzle (3).
5. Use Tool (D) to remove adapter (6) from the cylinder head.
6. Remove gasket (7) and seal (5) from adapter (6).
NOTE: The following steps are for installation of the fuel injection nozzles and adapters.
7. Use Tool (E) to clean the bore in adapter (6). Use an open end wrench or tap driver to turn Tool (E).
8. Inspect seal (5) for damage or wear. Replace the seal if necessary.
9. Put washer (7) and seal (5) in position on adapter (6).
10. Put liquid soap in the bores of the cylinder head and on seals (5) in the adapters.
11. Put 5P-3931 Anti-Seize Compound on the threads of adapter (6), and install the adapter in the cylinder head assembly.
12. Use Tool (D), and tighten the adapter to a torque of 205 ± 14 N·m (150 ± 10 lb ft).
| NOTICE |
|---|
Make sure the correct compression seal washer (4) is used when the nozzle assembly is installed in the adapter. Only copper washers are to be used with this adapter. |
13. Install compression seal washer (4), and use Tool (F) to install carbon dam seal (8) on the fuel injection nozzle.
14. Put fuel injection nozzle (3) in position in the adapter, and install retainer (2).
15. Use Tool (B) to tighten retainer (2) to a torque of 48 ± 7 N·m (35 ± 5 lb ft).
16. Install fuel line (1). Tighten the nuts on the fuel line with Tool (A) to a torque of 40 ± 7 N·m (30 ± 5 lb ft).
End By:
a. install valve covers