Engine Oil Pump - Remove and Install
Start By:
- Remove the oil pan.
- Drain the engine oil. Refer to Operation and Maintenance Manual, "Engine Oil - Change".
Show/hide table
Illustration 1 g06102341 - Remove bolts (1), bolt (3), and engine oil pump (2).
- Install engine oil pump (2) in the reverse order of removal.
Caterpillar Information System:
3516C Locomotive Engine Fuel Injector - Replace
C4.4 and C6.6 Engines Ether Starting Aid - Test
3516C Locomotive Engine Walk-Around Inspection
3516C Locomotive Engine Fuel System Primary Filter/Water Separator - Clean/Replace
C4.4 and C6.6 Engines Electrical Power Supply - Test
C4.4 and C6.6 Engines Data Link Configuration Status - Test
C4.4 and C6.6 Engines Data Link - Test
C175-16 Locomotive Engine Fuel Rail Pressure Problem
C2.4 Tier 4 Final Engines for Caterpillar Built Machines Engine Top Speed Is Not Obtained
C2.4 Tier 4 Final Engines for Caterpillar Built Machines Engine Stalls at Low RPM
C2.4 Tier 4 Final Engines for Caterpillar Built Machines Engine Shutdown Occurs Intermittently
C175-16 Locomotive Engine Fuel Rail Pressure Is High
PM820, PM822, and PM825 Cold Planer Machine Systems Coupling - Remove and Install
A New Exhaust Insulation Assembly Is Now Used on Certain PMG3516C Generator Sets {1061, 1067} A New Exhaust Insulation Assembly Is Now Used on Certain PMG3516C Generator Sets {1061, 1067}
C175-16 Engine for Off-Highway Trucks Pressure Sensor (NOx Reduction System)
C175-16 Engine for Off-Highway Trucks Refrigerant Compressor
C4.4 and C6.6 Engines Fuel Transfer Pump - Test
C4.4 and C6.6 Engines Glow Plug Starting Aid - Test
C175-16 Engine for Off-Highway Trucks Alternator Mounting
C4.4 and C6.6 Engines Idle Validation - Test
C4.4 and C6.6 Engines Indicator Lamp - Test
C175-16 Oil and Gas Generator Set Product Description
C175 Tier 4 Final Engines for Off-Highway Trucks Injector Solenoid - Test
Cat® Command For Hauling E1320