EMCP4.2B Caterpillar


Utility Circuit Breaker Status Warning

Usage:

C3.4B CF6
系统运作描述:

当以下两种情况发生时,公用电断路器不稳定、间歇或不正确状态的事故代码 3546-2 将变为现行状态:

  • 转换开关功能已启用。

  • 没有为公用电断路器 AUX A 配置的数字输入。

当存在为 AUX A 配置的输入且信号冲突时,也可能会激活此事件。

注: 与具有相同逻辑电平的信号有冲突。

测试步骤 1. 确认 EMCP 设定点

  1. 发电机/公用电自动转换启用状态参数用于打开或关闭公用电断路器状态警告。 参数默认设置为停用。 使用 EMCP 上的箭头按钮和 "OK" 按钮导航到"转换开关"。 在显示"配置"的屏幕中,按下箭头键选择"所有设定点"。 接着,选择"控制",然后选择"转换开关"。 然后按 "OK" 按钮。 将状态更改为启用或停用。

  2. 确认 EMCP 数字输入程序。 确保数字输入配置为公用电断路器" AUX A"。 如需导航到参数,在"配置"屏幕中,使用箭头键和 OK 按钮选择"输入和输出"。 接着,选择"数字输入"。

结果:

  • - 停止

Caterpillar Information System:

C1.7 and C2.2 Industrial Engines After Starting Engine
323F SA and 323F LN Excavator Hydraulic System Oil Filter (Return) - Replace
323F SA and 323F LN Excavator Hydraulic System Oil Level - Check
C1.7 and C2.2 Industrial Engines High Pressure Fuel Lines
C280-12 Marine Engine Engine Oil - Change
323F SA and 323F LN Excavator Hydraulic System Oil Filter (Pilot) - Replace
323F SA and 323F LN Excavator Hydraulic System Oil Filter (Case Drain) - Replace
C1.7 and C2.2 Industrial Engines Belts - Inspect/Adjust
323F SA and 323F LN Excavator Engine Oil and Filter - Change
2015/09/11 Cat® Reman Announces Engine, Short Block, and Long Block Options for Cat Electric Power Applications {1000}
Some Reman Water Pumps for Some 3606 Engines May Leak Oil{1361} Some Reman Water Pumps for Some 3606 Engines May Leak Oil{1361}
New Software Is Used on Certain C18 Marine Engines {1920} New Software Is Used on Certain C18 Marine Engines {1920}
C1.7 and C2.2 Industrial Engines Engine Operation
3516B Generator Set Engines with Dynamic Gas Blending Turbocharger Turbine Temperature Is High
2015/09/23 A New Head Gasket Is Used On Certain Truck Engines {1100}
3500 Industrial and Generator Set Engines Fluid Recommendations
A New Wiring Harness Is Used on Certain G3500 Engines {1403} A New Wiring Harness Is Used on Certain G3500 Engines {1403}
G3606 and G3608 Engines Engine Lifting Bracket - Remove and Install
A New Fuel Cap With Relief Vent Is Now Used on Certain XQ800 Power Modules {1273} A New Fuel Cap With Relief Vent Is Now Used on Certain XQ800 Power Modules {1273}
2015/09/11 New Software Is Used on Certain G3300 Petroleum Engines {1920}
An Improved Halogen Lamp is Now Available for Certain Excavators {1434} An Improved Halogen Lamp is Now Available for Certain Excavators {1434}
New Machining and Assembly Procedures Are Used on Certain C18 Marine Engines Equipped with Engine Mounted Heat Exchanger {1379} New Machining and Assembly Procedures Are Used on Certain C18 Marine Engines Equipped with Engine Mounted Heat Exchanger {1379}
WS223, WS223 SS, WS223 XD, WS255, WS255 SS, WS255 XD, WSP223, WSP255, WSF223, WSF223 SS, WSF223 XD, WSF255, WSF255 SS and WSF255 XD Well Stimulation Pumps Fluid End - Remove and Install
WS223, WS223 SS, WS223 XD, WS255, WS255 SS, WS255 XD, WSP223, WSP255, WSF223, WSF223 SS, WSF223 XD, WSF255, WSF255 SS and WSF255 XD Well Stimulation Pumps Valve - Remove and Install - Grooveless Valve Retainers
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.