Customer Specified Parameters Table
Show/hide table
Table for Customer Specified Parameters | ||
---|---|---|
Parameter | Available Range or Options | Default |
Selected Engine Rating | ||
Rating Number | Dependent on engine power | |
Multitorque Ratio | Unavailable
(Standard Ratings) MT-A MT-B MT-C |
Unavailable
(Standard Ratings) MT-A (Multitorque Ratings) |
Selected Engine Rating | ||
Vehicle ID | 17 Digits
Available characters are dependent on the service tools. |
all zeroes |
Security Access Parameters | ||
ECM Wireless Communication Enable | Yes
No |
No |
Vehicle Speed Parameters | ||
Vehicle Speed Calibration | |
Not Programmed |
Vehicle Speed Cal (J1939 - Trans) | 0 to 43000 revolutions per km (0 to 65000 revolutions per mile) | Not Programmed |
Vehicle Speed Cal (J1939 - ABS) | 0 to 6.550 | Not Programmed |
Vehicle Speed Limit | |
|
VSL Protection | 1000 to TEL rpm | TEL rpm |
Tachometer Calibration | 12.0 to 500.0 pulses per revolution | 113.0 pulses per revolution |
Soft Vehicle Speed Limit | Yes
No |
No |
Two Speed Axle - Low Speed Range Axle Ratio | 1.00 to 19.99 | 1.00 |
Nominal Axle Ratio - High Speed Range Axle Ratio | 1.0 to 9.99 | 1.00 |
Cruise Control Parameters | ||
Low Cruise Control Speed Set Limit | |
|
High Cruise Control Speed Set Limit | |
|
Cruise/Idle/PTO Switch Configuration | Set/Accel-Res/Decel
Set/Decel-Res/Accel |
Set/Accel-Res/Decel |
Soft Cruise Control | Yes
No |
Yes |
Adaptive Cruise Control Enable | Disabled
Enabled |
Disabled |
Idle Parameters | ||
Idle Vehicle Speed Limit | |
|
Idle RPM Limit | Low Idle to 2120 rpm | 2120 rpm |
Idle/PTO RPM Ramp Rate | 5 to 1000 rpm/sec | 50 rpm/sec |
Idle/PTO Bump RPM | 5 to 500 rpm | 20 rpm |
Dedicated PTO Parameters | ||
PTO Configuration | Cab Switches
Off Remote Switches Remote Throttle |
Off |
PTO Top Engine Limit | Low Idle to 2120 rpm | 2120 rpm |
PTO Engine RPM Set Speed (0 = Off) | Low Idle to PTO TEL rpm | 0 |
PTO Engine RPM Set Speed A | Low Idle to PTO TEL rpm | 0 |
PTO Engine RPM Set Speed B | Low Idle to PTO TEL rpm | 0 |
PTO to Set Speed | Yes
No |
No |
Maximum PTO Enable Speed | Low Idle to PTO TEL rpm | PTO TEL rpm |
PTO Cab Controls RPM Limit | Low Idle
TEL PTO TEL |
TEL |
PTO Kickout Vehicle Speed Limit | |
|
Max PTO Vehicle Speed | |
|
Torque Limit | 270 N·m (200 lb ft) to Rated Torque | |
PTO Shutdown Time (0 = Off) | 3 to 1440 minutes | 0 |
PTO Shutdown Timer Maximum RPM | 600 to PTO TEL rpm | PTO TEL rpm |
PTO Activates Cooling Fan | Normal
Continuous |
Normal |
Engine/Gear Parameters | ||
Lower Gears Engine RPM Limit | 1100 to TEL rpm | TEL rpm |
Lower Gears Turn Off Speed | |
|
Intermediate Gears Engine RPM Limit | 1100 to TEL rpm | TEL rpm |
Intermediate Gears Turn Off Speed | |
|
Gear Down Protection RPM Limit | 1300 to TEL rpm | TEL rpm |
Gear Down Protection Turn On Speed | |
|
Low Idle Engine RPM | 600 to 750 rpm | 600 rpm |
Transmission Style | Automatic Option 1
Automatic Option 2 Automatic Option 3 Automatic Option 4 Eaton Top 2 Manual Option 1 |
Manual Option 1 |
Eaton Top 2 Override with Cruise Switch | Yes
No |
No |
Top Gear Ratio | 0.000 to 3.750 | 0.000 |
Top Gear Minus One Ratio | 0.000 to 3.750 | 0.000 |
Top Gear Minus Two Ratio | 0.000 to 3.750 | 0.000 |
Governor Type | Full Range
Min/Max Min/Max with Speed Control |
Full Range |
Default Torque Limit Master Source Address (C13 RLG only) | 0 to 253 | 0 (disabled) |
Timer Parameters | ||
Idle Shutdown Time (0 = Off) | 1 to 1440 minutes | 0 minutes |
Idle Shutdown Timer Maximum RPM | Low Idle to 2120 rpm | 2120 rpm |
Allow Idle Shutdown Override | Yes
No J1587 Outside Temp Based Outside Temperature Based |
Yes |
Minimum Idle Shutdown Outside Temp | |
|
Maximum Idle Shutdown Outside Temp | |
|
A/C Switch Fan On-Time (0 = Off) | 1 to 600 seconds | 0 seconds |
Smart Idle Parameters | ||
Battery Monitor and Engine Control Voltage | 0 to 25.5 volts | 0.0 volts |
Engine Monitoring Parameters | ||
Engine Monitoring Mode | Warning
Derate Shutdown |
Warning |
Engine Monitoring Lamps | Option 1
Warning Lamp |
Warning Lamp |
Coolant Level Sensor | 2-wire Float Sensor
4-pin No |
No |
Engine Coolant Temperature Derate Enable Status
This parameter is not supported in DEC 2003 and newer software. |
Enabled
Disabled |
Disabled |
Maintenance Parameters | ||
Maintenance Indicator Mode | Automatic Distance
Automatic Hours Manual Distance Manual Hours Off |
Off |
PM 1 Interval (Manual Maintenance Indicator Mode) | 100 to 750 hours |
250 hours |
Engine Oil Capacity | |
C11, C13: C15: |
Trip Parameters | ||
Fuel Correction Factor | −63.5 to 63.5 % | 0 % |
Dash-Change Fuel Correction Factor | Yes
No |
No |
Dash-PM 1 Reset | Yes
No |
No |
Dash-Fleet Trip Reset | Yes
No |
No |
Dash-State Selection | Yes
No |
Yes |
Theft Deterrent System Control | Yes
No Auto-Enable |
No |
Theft Deterrent Password | Four Characters | 0000 |
Quick Stop Rate | 5 to 24 km/h per sec (3 to 15 mph per sec) | 0 km/h per sec (0 mph per sec) |
Vehicle Overspeed Threshold | |
|
Vehicle Activity Report Parameters | ||
Minimum Idle Time (0 = Off) | 0 to 1440 minutes | 0 minutes |
Driver Reward | ||
Driver Reward Enable | Enabled
Disabled |
Enabled |
Input Selections | ||
Fan Override Switch | None
J1/P1:46 J1/P1:47 J1/P1:6 J1/P1:7 J1939 - Body Controller J1939 - Cab Controller J1939 - Instrument Cluster |
None |
Transmission Neutral Switch | None
J1939 J1/P1:62 |
None |
Ignore Brake/Clutch Switch | None
J1/P1:47 |
None |
Torque Limit Switch | None
J1/P1:7 |
None |
Diagnostic Enable | None
J1/P1:46 J1939 - Body Controller J1939 - Cab Controller J1939 - Instrument Cluster |
None |
PTO On/Off Switch | J1/P1:56
J1939 - Body Controller J1939 - Cab Controller J1939 - Instrument Cluster |
J1/P1:56 |
Remote PTO Set Switch | None
J1/P1:58 J1939 - Body Controller J1939 - Cab Controller J1939 - Instrument Cluster |
J1/P1:58 |
Remote PTO Resume Switch | None
J1/P1:60 J1939 - Body Controller J1939 - Cab Controller J1939 - Instrument Cluster |
J1/P1:60 |
PTO Engine RPM Set Speed Input A | None
J1/P1:6 J1/P1:46 J1/P1:58 J1/P1:60 J1939 - Body Controller J1939 - Cab Controller J1939 - Instrument Cluster |
None |
PTO Engine RPM Set Speed Input B | None
J1/P1:6 J1/P1:46 J1/P1:58 J1/P1:60 |
None |
Starting Aid On/Off Switch | None
J1/P1:6 J1/P1:7 J1/P1:46 J1/P1:47 |
None |
Two-Speed Axle Switch | None
J1/P1:6 J1939 - Body Controller J1939 - Cab Controller J1939 - Instrument Cluster |
None |
Cruise Control On/Off Switch | J1/P1:59
J1939 - Body Controller J1939 - Cab Controller J1939 - Instrument Cluster |
J1/P1:59 |
Cruise Control Set/Resume/Accel/Decel Switch | J1/P1:35 & 44
J1939 - Body Controller J1939 - Cab Controller J1939 - Instrument Cluster |
J1/P1:35 & 44 |
Cruise Control Pause Switch | None
J1939 - Body Controller J1939 - Cab Controller J1939 - Instrument Cluster |
None |
Clutch Pedal Position Switch | J1/P1:22
J1939 - Body Controller J1939 - Cab Controller J1939 - Instrument Cluster |
J1/P1:22 |
Service Brake Pedal Position Switch #1 | J1/P1:45
J1939 - Body Controller J1939 - Cab Controller J1939 - Instrument Cluster |
J1/P1:45 |
Accelerator Pedal Position | J1/P1:66 | J1/P1:66 |
Vehicle Speed Input | J1/P1:32 & 33
J1939 − ABS J1939 − Trans |
J1/P1:32 & 33 |
Output Selections | ||
Engine Running Output | None
J1/P1:10 J1/P1:12 J1/P1:13 |
None |
Engine Shutdown Output | None
J1/P1:10 J1/P1:12 J1/P1:13 |
None |
Auxiliary Brake | None
J1/P1:12 |
None |
Starting Aid Output | None
J1/P1:10 J1/P1:12 J1/P1:13 |
None |
Fan Control Type | None
On/Off PWM On/Off DC Three-Speed Fan PWM Three-Speed Fan DC Variable Speed Fan Option S |
None |
PTO Active Output | None
J1/P1:19 |
None |
Customer Passwords | ||
Customer Password #1 | 8 Digits
Available characters are dependent on the service tools. |
Not Programmed |
Customer Password #2 | ||
Data Link Parameters | ||
Power Train Data Link | None
J1939 |
J1939 |
Caterpillar Information System:
C13 and C15 Engines for Combat and Tactical Vehicles Customer Specified Parameters
390F Excavator DEF Manifold Filters - Replace
C13 and C15 Engines for Combat and Tactical Vehicles 0231-14 Transmission Data Link Derate
C13 and C15 Engines for Combat and Tactical Vehicles Retarder (Compression Brake) Solenoid Circuit - Test
C13 and C15 Engines for Combat and Tactical Vehicles Intake Valve Actuator Response - Test
C13 and C15 Engines for Combat and Tactical Vehicles Injector Solenoid Circuit - Test
C13 and C15 Engines for Combat and Tactical Vehicles Idle Shutdown Timer - Test
C13 and C15 Engines for Combat and Tactical Vehicles Engine Pressure Sensor Open or Short Circuit - Test
C13 and C15 Engines for Combat and Tactical Vehicles Cooling Fan Circuit and A/C High Pressure Switch Circuit - Test
C13 and C15 Engines for Combat and Tactical Vehicles 0110-11 Very High Coolant Temperature (61)
C13 and C15 Engines for Combat and Tactical Vehicles 0110-00 High Coolant Temperature Warning (61)
C13 and C15 Engines for Combat and Tactical Vehicles 0100-11 Very Low Oil Pressure (46)
C13 and C15 Engines for Combat and Tactical Vehicles Customer Specified Parameters Worksheet
EMCP 4.4 Supervisory Control Panel Generator Loading
Installation Of Operator ID System on Cat® and Non-Cat Products {7600, 7610, 7620} Installation Of Operator ID System on Cat® and Non-Cat Products {7600, 7610, 7620}
New Software Is Used on Certain C18 Marine Engines {1920} New Software Is Used on Certain C18 Marine Engines {1920}
Some Reman Water Pumps for Some 3606 Engines May Leak Oil{1361} Some Reman Water Pumps for Some 3606 Engines May Leak Oil{1361}
2015/09/11 Cat® Reman Announces Engine, Short Block, and Long Block Options for Cat Electric Power Applications {1000}
323F SA and 323F LN Excavator Engine Oil and Filter - Change
C1.7 and C2.2 Industrial Engines Belts - Inspect/Adjust
323F SA and 323F LN Excavator Hydraulic System Oil Filter (Case Drain) - Replace
323F SA and 323F LN Excavator Hydraulic System Oil Filter (Pilot) - Replace
C280-12 Marine Engine Engine Oil - Change
C1.7 and C2.2 Industrial Engines High Pressure Fuel Lines