Maintenance Interval Schedule
Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed. The user is responsible for the performance of maintenance, including all adjustments, the use of proper lubricants, fluids, filters, and the installation of new components due to normal wear and aging. The performance of this product may be diminished if proper maintenance intervals and procedures are not followed. Components may experience accelerated wear if proper maintenance intervals and procedures are not followed.
Exhaust Inlet Nitrogen Oxide Sensor - Replace
Exhaust Outlet Nitrogen Oxide Sensor - Replace
Overhaul (Top End)
Overhaul (Major)
Note: Use whichever of the following that occurs first in order to determine the maintenance intervals: service hours and calendar time . Before each consecutive interval is performed, all maintenance from the previous intervals must be performed.
Products that operate in severe operating conditions may require more frequent maintenance.
Daily
Walk-Around InspectionEvery 1000 Service Hours or Every 92 Day FRA Inspection
Hoses and Clamps - Inspect/ReplaceEvery Year
Diesel Exhaust Fluid Nozzle - Inspect/CleanEvery 2 Years
Catalyst (DOC) - Clean/InspectExhaust Inlet Nitrogen Oxide Sensor - Replace
Exhaust Outlet Nitrogen Oxide Sensor - Replace
Overhaul
Maintenance RecommendationsOverhaul (Top End)
Overhaul (Major)
Caterpillar Information System:
C175-16 Locomotive Engine Coolant Temperature Is Low
C13 Engine for Caterpillar Built Machines Crankshaft - Remove and Install
C13 Engine for Caterpillar Built Machines Crankshaft Main Bearings - Remove and Install
C13 Engine for Caterpillar Built Machines Connecting Rod Bearings - Remove and Install
C13 Engine for Caterpillar Built Machines Cylinder Liner - Remove and Install
C13 Engine for Caterpillar Built Machines Camshaft Bearings - Remove and Install
C175-16 Locomotive Engine Prelubrication - Test
C175-16 Locomotive Engine Injector Solenoid - Test
C13 Engine for Caterpillar Built Machines Camshaft - Remove and Install
3512E HD Petroleum Engine Plate Locations and Film Locations
C175-16 Locomotive Engine Fuel Priming Pump - Test
C175-16 Locomotive Engine Fuel Control - Test
TA2 Technical Inspection for G3516H Engines{1000, 7565} TA2 Technical Inspection for G3516H Engines{1000, 7565}
C280-16 Engine Engine Oil Filter Elements - Remove and Install
390F MHPU Mobile Hydraulic Power Unit Diesel Exhaust Fluid - Fill
374F Excavator Cooling System Coolant Level - Check
3512C Petroleum Engines with Dynamic Gas Blending Air Shutoff - Test
CEM Locomotive Aftertreatment Configuration Parameters
301.5, 301.6, 301.7 CR, 301.8 and 302 CR Mini Hydraulic Excavators Work Tools
301.5, 301.6, 301.7 CR, 301.8 and 302 CR Mini Hydraulic Excavators Operation
C280-16 Engine Vibration Damper - Remove and Install
C13, C15, and C18 Tier 4 Final Engines Nitrogen Oxide Sensor
3512E Tier 4 Final Engines for Land Electric Drilling Coolant Temperature Is Low
2013/05/17 New Instrument Panel Box Gp Is Now Available On Certain Cat® Engines and Gensets {7451}