Electric Starting Motor
Show/hide table
Illustration 1 | g00379835 |
Starting motor and starting motor solenoid |
No load conditions at
- Rpm with no load ... 4000 rpm to 6000 rpm
- Maximum current ... 540 A
- Current draw with no load ... 130 A
- Voltage ... 11.5 V
- Rated voltage ... 12 V
- Maximum current ... 540 A
Power rating ... 2 kW
Minimum average cranking rpm ... 130
Starting motor solenoid
- Pull-in current ... 54.5 A
- Hold-in current ... 10.5 A
(1) Tighten the battery terminal nut to the following torque. ...
(2) Tighten the two mounting bolts to the following torque. ...
(3) Tighten the nut for the switch terminal to the following torque. ...
Maximum resistance of the starter cable at
Caterpillar Information System:
C1.5 and C2.2 Engines for Caterpillar Built Machines Alternator and Regulator
C1.5 and C2.2 Engines for Caterpillar Built Machines Engine Oil Pressure Switch
C1.5 and C2.2 Engines for Caterpillar Built Machines Exhaust Manifold
C1.5 and C2.2 Engines for Caterpillar Built Machines Fuel Injection Pump
C1.5 and C2.2 Engines for Caterpillar Built Machines Fuel Injection Nozzles
C1.5 and C2.2 Engines for Caterpillar Built Machines Gear Group (Front)
C18 Marine Auxiliary and Marine Generator Set Engines Cooling System
Set up Procedure for the Low-Pressure Fuel System of 3600 and C280 Diesel Engines{1250} Set up Procedure for the Low-Pressure Fuel System of 3600 and C280 Diesel Engines{1250}
Failure of Digital Communication Unit (DCU) Crank Output on Certain Cat® Engines{7451} Failure of Digital Communication Unit (DCU) Crank Output on Certain Cat® Engines{7451}
O-Rings - Radial, Fitting Assembly O-Rings and Other O-Ring Applications {0599, 0738, 4000, 4250, 4300, 5050, 5057, 7555} O-Rings - Radial, Fitting Assembly O-Rings and Other O-Ring Applications {0599, 0738, 4000, 4250, 4300, 5050, 5057, 7555}
C175-16 Locomotive Engine Inlet Manifold
C175-16 Locomotive Engine Component Location
3516B and 3516C Engines For MT4400D AC Off-Highway Trucks Electronic Service Tool Does Not Communicate
C280 Marine and Petroleum Engines Electrical Power Supply - Test
C280 Marine and Petroleum Engines Solenoid Valve - Test
Cat® Command for Hauling - 793F CMD Onboard Autonomy Setup and Configuration Guide {7605, 7610, 7620} Cat® Command for Hauling - 793F CMD Onboard Autonomy Setup and Configuration Guide {7605, 7610, 7620}
C1.5 and C2.2 Engines for Caterpillar Built Machines Coolant Temperature Sensor
3516B Engine for the MT4400D Off-Highway Truck Air Lines - Aftercooler
C1.5 and C2.2 Engines for Caterpillar Built Machines Speed/Timing Sensor
TA2 Technical Inspection for 3516B and 3516C Engines For MT4400D AC Off-Highway Trucks{1000} TA2 Technical Inspection for 3516B and 3516C Engines For MT4400D AC Off-Highway Trucks{1000}
C1.5 and C2.2 Engines for Caterpillar Built Machines Boost Pressure Sensor - If equipped
CG137-08 and CG137-12 Engines Engine Oil Filter Base - Remove and Install - G3408B
C1.5 and C2.2 Engines for Caterpillar Built Machines Inlet Manifold Temperature Sensor
Procedure to Rework Exhaust Shield and Seal on Certain Machine and Commercial Engines {1059, 7555} Procedure to Rework Exhaust Shield and Seal on Certain Machine and Commercial Engines {1059, 7555}