Electric Starting Motor - Remove and Install
Removal Procedure
Show/hide table
Personal injury can result from failure to disconnect the battery. First, disconnect the negative battery cable. Then, disconnect the positive battery cable. A positive power lead can cause sparks if the battery is not disconnected. Sparks can possibly result in battery explosion or fire. |
- Place an index mark on all of the harness assemblies. Disconnect the harness assemblies from electric starting motor (1) .
Show/hide table
Illustration 1 | g01063153 |
- Fasten a suitable lifting device to electric starting motor (1). The weight of electric starting motor (1) is approximately 35 kg (77 lb).
- Remove bolts (2) .
- Remove electric starting motor (1) and the gasket from the flywheel housing.
Installation Procedure
- Fasten a suitable lifting device to electric starting motor (1). The weight of electric starting motor (1) is approximately 35 kg (77 lb).
Show/hide table
Illustration 2 | g01063153 |
- Position the gasket and electric starting motor (1) in the flywheel housing. Install bolts (2) .
- Connect the harness assemblies to electric starting motor (1). Refer to Specifications, "Electric Starting Motor".
Caterpillar Information System:
C7 Engine for Combat and Tactical Vehicles Alternator - Remove and Install
C7 Engine for Combat and Tactical Vehicles Engine Control Module - Remove and Install
C7 Engine for Combat and Tactical Vehicles Fan Drive Mounting Group - Remove and Install
C7 Engine for Combat and Tactical Vehicles Inlet Air Temperature Sensor - Remove and Install
C7 Engine for Combat and Tactical Vehicles Boost Pressure Sensor - Remove and Install
C7 Engine for Combat and Tactical Vehicles Speed/Timing Sensor - Remove and Install
C7 Engine for Combat and Tactical Vehicles Injection Actuation Pressure Sensor - Remove and Install
C7 Engine for Combat and Tactical Vehicles Engine Oil Pressure Sensor - Remove and Install
C7 Engine for Combat and Tactical Vehicles Coolant Temperature Sensor - Remove and Install
C7 Engine for Combat and Tactical Vehicles Atmospheric Pressure Sensor - Remove and Install
C9 Marine Auxiliary and Generator Set Engines Emissions Certification Film
C7 Engine for Combat and Tactical Vehicles Bearing Clearance - Check
C7 Engine for Combat and Tactical Vehicles Air Compressor - Remove and Install
C7 Engine for Combat and Tactical Vehicles Air Compressor Drive Gear - Remove
C7 Engine for Combat and Tactical Vehicles Air Compressor Drive Gear - Install
C175 Generator Sets System Pressure Release
C15 and C18 Industrial Engines Temperature Sensor (DPF) - Remove and Install - Clean Emissions Module
C13, C15, and C18 Tier 4 Interim Engines ECM - Replace
2009/04/27 Proper Long Term Storage of Caterpillar Products {0355, 1000, 7000}
C7.1 Industrial Engine Electrical System
C15 and C18 Industrial Engines Pressure Sensor (DPF) - Remove and Install
Adjustment of Overload Protection for Generators{4450, 4493} Adjustment of Overload Protection for Generators{4450, 4493}
3500B and 3500C Marine Engines Alternator and Regulator
C13, C15, and C18 Generator Set Engines Belt Tightener