Wiring Harness (Open Circuit) - Test
开路是导致电路中没有电流的故障根源。 开路可能是由电路内导线断开导致。 大多数情况下，开路都是由不良连接引起。 开路也可能是由电路中使用的某个电气接头中存在连接故障导致。
以下步骤是一种检查电路中有无开路或不良连接的方法。
Show/hide table
| 故障诊断与排除测试步骤 | 数值 | 结果 |
|---|---|---|
| 1. 确定开路 A. 确定可疑电路中的接头和导线编号。 使用机器的电气系统示意图检查电路。 B. 将钥匙起动开关和断路开关转到断开位置。 C. 从配线线束上断开部件和 ECM。 D. 在一个断开的线束连接上，将一根跨接导线连在可疑导线的触点与机架接地之间。 E. 在机器线束的其他接头上，使用万用表表笔测量电阻。 测量可疑导线触点与机架接地之间的电阻。 |
电阻小于 5 Ω。 |
正常 - 线束电路正常。 停止。 不正常 - 电阻大于 5K Ω。 机器线束中存在断路。 修理：修理或更换机器线束。 注：电阻大于 5 Ω 但小于 5K Ω 表示电路中的连接松动或腐蚀。 电阻测量值大于 5K Ω 表示电路中存在开路。 停止。 |
Caterpillar Information System:
966M and 972M Wheel Loaders Ride Control Accumulator - Check
966M and 972M Wheel Loaders Seat Belt - Inspect
980H Wheel Loader Electrohydraulic System Pilot Valve (Oil Manifold)
980H Wheel Loader Steering System Relief Valve
980H Wheel Loader Electrohydraulic System Oil Filter (Hydraulic)
980H Wheel Loader Steering System Wiring - secondary steering
980H Wheel Loader Electrohydraulic System Pressure Sensor (Lift Cylinder Oil) (Autodig, Payload)
980H Wheel Loader Steering System Steering Lines
980H Wheel Loader Steering System Steering Cylinder and Mounting
D5N Track-Type Tractor TA2 Technical Inspection{0372, 1000, 7000, 753T, 7565} D5N Track-Type Tractor TA2 Technical Inspection{0372, 1000, 7000, 753T, 7565}
980H Wheel Loader Electrohydraulic System Main Control Valve and Mounting
980H Wheel Loader Electrohydraulic System Main Control Valve and Mounting - Block Handling
621H, 623H and 627H Wheel Tractor-Scrapers Hydraulic and Steering System Relief Valve (Push-Pull) - Test and Adjust
349F and 352F Excavator Machine System Wiring Harness (Short Circuit) - Test
980H Wheel Loader Machine Systems Refrigerant Compressor
966M and 972M Wheel Loaders Radiator Core - Clean
980H Wheel Loader Steering System Steering Cylinder and Mounting
349F and 352F Excavators Parking
D6T Track-Type Tractor Pivot Shaft Oil Level - Check
D6T Track-Type Tractor Radiator Pressure Cap - Clean/Replace
D6T Track-Type Tractor Recoil Spring Compartment Oil Level - Check
D6T Track-Type Tractor Refrigerant Dryer - Replace - If Equipped
2013/09/20 The Brake Lines Group and Fuel Lines Group Has Been Updated on Certain 627H Wheel Tractor-Scrapers {1274, 4257}
Procedure to Update Hydraulic System Capability on Certain 950K Wheel Loaders Equipped with Forestry Package{5051, 5057, 5077, 5264, 5453, 7610, 7620} Procedure to Update Hydraulic System Capability on Certain 950K Wheel Loaders Equipped with Forestry Package{5051, 5057, 5077, 5264, 5453, 7610, 7620}