Electronic Control Module (ECM) - Flash Program
Perform the following procedure in order to flash program the ECM. The ECM is flashed in order to upgrade the software. Flash programming of the ECM must also be done if the ECM has been replaced. The Caterpillar Electronic Technician (ET) contains the program WinFlash. WinFlash is used in order to load software into the ECM. The following procedure is used in order to FLASH software into the ECM.
- Procedure
- Connect the data link cable between the communication adapter and the electronic technician.
- Connect the data link cable between the communication adapter and the diagnostic connector of the machine.
- Turn the disconnect switch and the key start switch to the ON position.
- Set the implement lockout to the LOCKED position.
- Ensure that the transmission direction switch is in the neutral position.
- Ensure that the engine is not running.
- Use WinFlash in order to load the software.
Caterpillar Information System:
966H, 972H and 980H Wheel Loaders Electrohydraulic System Electronic Control Module (ECM) - Replace
966H, 972H and 980H Wheel Loaders Electrohydraulic System Electrical Connector - Inspect
966H, 972H and 980H Wheel Loaders Electrohydraulic System Wiring Harness (Short Circuit) - Test
966H, 972H and 980H Wheel Loaders Electrohydraulic System Wiring Harness (Open Circuit) - Test
Procedure to Replace the 321-4673 Fuel Tank As on Certain AD30 Underground Articulated Trucks{1273} Procedure to Replace the 321-4673 Fuel Tank As on Certain AD30 Underground Articulated Trucks{1273}
966M Tier 4 and 972M Tier 4 Wheel Loaders Power Train Relief Valve (Torque Converter Outlet) - Remove and Install
525D, 535D, 545D, 555D Wheel Skidder Cooling System Coolant Extender (ELC) - Add
525D, 535D, 545D, 555D Wheel Skidder Cooling System Coolant (ELC) - Change
525D, 535D, 545D, 555D Wheel Skidder Circuit Breakers - Reset
903C Compact Wheel Loader Quick Coupler - Lubricate
525D, 535D, 545D, 555D Wheel Skidder Cab Air Filter - Clean/Replace
D9T Track-Type Tractor Systems Electronic Control (Fan Hydraulic System)
966H, 972H and 980H Wheel Loaders Electrohydraulic System Electronic Control Module (ECM) - Configure
966H, 972H and 980H Wheel Loaders Electrohydraulic System Calibration
966H, 972H and 980H Wheel Loaders Electrohydraulic System Position Sensor for the Electrohydraulic Control Levers or Joystick Control (Electronic Technician) - Calibrate
966H, 972H and 980H Wheel Loaders Electrohydraulic System Position Sensor for the Lift and Tilt Linkage (Electronic Technician) - Calibrate
966H, 972H and 980H Wheel Loaders Electrohydraulic System Main Control Valve (Electronic Technician) - Calibrate
966H, 972H and 980H Wheel Loaders Electrohydraulic System Piston Pump (Implement) Margin Pressure - Test and Adjust
D6N Track-Type Tractor Power Train Relief Valve (Transmission Hydraulic Control)
903C Compact Wheel Loader Radiator Core - Clean
988K Wheel Loader Sensor Signal (Analog, Active) - Test
631K Wheel Tractor-Scraper Retarding
D6N Track-Type Tractor Machine Systems Bulldozer Trunnion
2013/05/14 An Improved Track Roller Frame is Now Used on Certain D6N and D5R Track-Type Tractors {4151}