Required Tools | |||
---|---|---|---|
Tool | Part Number | Part Description | Qty |
A | 180-3032 | Jack Stand Gp | 1 |
B | 138-7575 | Link Bracket | 4 |
C | 8T-4835 | Bolt | 1 |
Note: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision component. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.
Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
- Position thrust washer (11), bearing (10), and gear (9).
Show/hide table
Illustration 2 g01379966 Show/hide tableIllustration 3 g01379965 - Position thrust washer (8). Use Tooling (C) in order to install shaft assembly (7). Remove Tooling (C). Install bolt (6).
Show/hide table
Illustration 4 g01379964 - Install cover (5).
Show/hide table
Illustration 5 g01379963 - Raise the temperature of bearings (4). Install bearings (4).
Show/hide table
Illustration 6 g01379962 Show/hide tableIllustration 7 g01379961 - Install gear (3) onto cover assembly (2).
- Position cover assembly (2) and gear (3). Install bolts (1).
- Remove the transmission from Tooling (A) and suitable blocking, if necessary. The weight of the transmission is approximately
1588 kg (3500 lb) . Remove Tooling (B) and a suitable lifting device from the transmission.
Illustration 1 | g01379967 |