Cylinder Head
Show/hide table
Illustration 1 | g01138617 |
(1) Large bolts
(2) Small bolts
Note: Lubricate the following components with 6V-4876 Lubricant : the bolt threads, the underside of the bolt heads and the washers.
Tighten the cylinder head bolts according to the following procedure:
- Tighten bolt (1) through bolt (14) in a numerical sequence to a torque of 300 ± 15 N·m (220 ± 11 lb ft).
- Loosen bolt (1) through bolt (14) until the washers are loose under the bolt heads.
- Tighten bolt (1) through bolt (14) in a numerical sequence to a torque of 130 ± 15 N·m (95 ± 11 lb ft).
- Again tighten bolt (1) through bolt (14) in a numerical sequence to a torque of 130 ± 15 N·m (95 ± 11 lb ft).
- Turn bolt (1) through bolt (14) in a numerical sequence for an additional 90° (1/4 turn).
- Tighten bolt (15) through bolt (20) in a numerical sequence to a torque of 55 ± 7 N·m (41 ± 5 lb ft).
(3) The installation depth of the cup plug is measured from the face of the cylinder head to the top edge of the plug. Depth of installation ... 1.25 ± 0.25 mm (0.049 ± 0.001 inch)
Show/hide table
Illustration 2 | g01138623 |
(4) Unit injector sleeve
Refer to Special Instruction, SEHS9120 for information on replacing unit injector sleeves.
(5) Height of a new 133-3742 Cylinder Head Gp ... 158.00 ± 0.15 mm (6.221 ± 0.006 inch)
Caterpillar Information System:
CX31 On-Highway Transmission Retarder Hydraulic Control Valve
TH48-E80 Petroleum Transmission Maximum Pressure for Lockup Clutch and Solenoid Valve (Torque Converter) - Test
C15 Petroleum Generator Set Engines Cylinder Head Valves
C7 Marine Engine Flywheel
C7 Marine Engine Flywheel
TH48-E80 Petroleum Transmission Transmission Troubleshooting
325D and 329D Excavators and 325D Material Handler Machine System Specifications Cab
C12 Marine Engines Engine Monitoring System (EMS)
CX31 On-Highway Transmission Modulating Valve (Torque Converter Lockup Clutch)
320D and 323D Excavators Machine System Specifications Hydraulic Pedal Control (Auxiliary)
C11 and C13 Engines Engine Support (Front)
C6.6 Engines for Caterpillar Built Machines Alternator
2005/12/12 Shop Chemicals are now Listed in Cat Shop Supplies and Hand Tools {0599, 0644, 0645}
C3.3 Industrial Engine Alternator and Fan Belts - Inspect/Adjust/Replace
C3.3 Industrial Engine Engine Mounts - Inspect
C3.3 Industrial Engine Engine Oil and Filter - Change
C3.3 Industrial Engine Engine Valve Lash - Inspect/Adjust
C27 PET GEN SET Electric Power Generation and C27 KNOCKDOWN K Petroleum Power Train Package Circuit Breakers - Reset
C15 Petroleum Generator Set Engines Valve Mechanism Cover
3500B Engines Radiator Group - Remove
C11 and C13 Engines Turbocharger
3500B Engines Radiator Group - Install
3500 Engines Fan Drive - Remove
2006/01/02 New Sequence for Adjusting the Fuel Injectors {1290, 1290}