Engine Oil Relief Valve - Remove and Install - Engine with Balancer Group
Start By:
- Remove the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove and Install".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove plug (2). Remove spring (3) and plunger (4) from balancer group (1).
- Check the spring and the plunger for wear or for other damage. The plunger (4) must slide easily in the balancer group.
Show/hide table
Illustration 1 | g00979780 |
Show/hide table
Personal injury can result from being struck by parts propelled by a released spring force. Make sure to wear all necessary protective equipment. Follow the recommended procedure and use all recommended tooling to release the spring force. |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Clean the spring and the plunger of the engine oil relief valve. Lubricate the spring and the plunger with clean engine oil.
Show/hide table
Illustration 2 g00979780 Show/hide tableImproper assembly of parts that are spring loaded can cause bodily injury.
To prevent possible injury, follow the established assembly procedure and wear protective equipment.
- Install plunger (4) and spring (3) in balancer group (1).
- Install plug (2). Tighten the plug to a torque of
22 N·m (16 lb ft) .
End By:
- Install the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove and Install".
Caterpillar Information System:
Cold Weather Recommendations for On-Highway Diesel Truck Engines Fuel Recommendations
G3500B Engines Engine Oil Lines
G3500B Engines Engine Oil Lines - Turbocharger Oil Lines
EMCPII+ for Gas Engines Indicator for Low Oil Pressure
EMCPII+ for Gas Engines Indicator for High Water Temperature
EMCPII+ for Gas Engines Indicator for Emergency Stop
G3520B Engines +5V Sensor Voltage Supply
G3500B Engines Engine Oil Lines
EMCPII+ for Gas Engines GSC CID 0770 - FMI 09
EMCPII+ for Gas Engines GSC CID 0590 - FMI 09
C9 Marine Engines and C9 Marine Generator Sets Air Cleaner Housing - Remove and Install
2003/03/01 Identifying the Correct Crankshaft Gear {1204}
Cold Weather Recommendations for On-Highway Diesel Truck Engines Coolant Recommendations
2003/03/01 Use the Correct Tooling for Installing Piston Rings {1214, 1215}
2003/08/01 Component-Based Troubleshooting is Available {7569}
G3500B Engines Engine Oil Filter - Duplex
C3.3 Industrial Engine Compression - Test
G3520B Industrial Engine +8V Sensor Voltage Supply
3176C and 3196 Engines for Caterpillar Built Machines Inlet Manifold Temperature Sensor
G3500B Engines Thermostatic Valve
2003/04/01 New Piston and Rod Group that Improves Cold Weather Operation {1225}
3500B Engines Engine Oil Sump Pump
C4.4 Industrial Engine Cooling System - Inspect
C3.3 Industrial Engine Water Temperature Regulator - Test