Usage:
NOTE: The information supplied in this service letter may not be valid after the termination date of this program. Do not perform the work outlined in this Service Letter after the termination date without first contacting your Caterpillar product analyst.
Termination Date
June 30, 1999Problem
0R0824, 0R2089, 0R2128, 0R2170, 0R2586, and 0R666 Remanufactured Cylinder Heads for D343 Engines in dealer parts stock may have a 9F2247 Pipe Plug installed too deep into the threaded hole blocking the oil passage and reducing the flow of oil through the head.
Action Required
Remanufactured Cylinder Heads for D343 Engines in dealer parts stock need to be inspected. The part numbers that may be affected by this problem are:
Inspection Procedure:
While the head is still on the box, locate the pipe plug on the side of the head. When looking at the head, with exhaust side toward you (angled side) the plug is located in the center area of the left side of the head.
Check with a Allen wrench if the plug is tight, if it is,check visually if the end of the plug is between the surface of the head and the counterbore of the hole. If these two checks are OK, the head is GOOD.
If the plug is not tight, it needs to be tighten to 16 N·m (12 LB ft) and then check visually if the end of the plug is between the surface of the head and the counterbore of the hole, again if both checks are OK the head is GOOD.
If the inspector can not determine if the top of the pipe plug is between the top of the head and the counterbore of the hole or if the plug is deeper that the counterbore of the hole, then the inspector needs to take the head out of the box, and place it on its side to inspect visually if the oil passage has been obstructed.
If the inspector can see the plug inside the oil passage more than .040" (1 mm or about 3 threads of the plug), the head should be returned.
Service Claim Allowances
Submit one claim for all 0R0824, 0R2089, 0R2128, 0R2170, 0R2586, and 0R2666 Remanufactured Cylinder Heads removed from dealer parts stock.
Parts Disposition
NOTE: All dealers are to make sure the oustide of the shipping container is marked PI7416.
U.S. And Canadian Dealers
Return all 0R0824, 0R2089, 0R2128, 0R2170, 0R2586, and 0R2666 Remanufactured Cylinder Heads that are removed from dealer Parts Stock and a copy of the claim to:
Attn: Billy Luker \ PI7416
Warranty Review
501 Cardinal Drive
Corinth, MS 38834
COSA Dealers
Return all 0R0824, 0R2089, 0R2128, 0R2170, 0R2586, and 0R2666 Remanufactured Cylinder Heads that are removed from Parts Stock and a copy of the claim to:
Warranty Claims Area \ PI7416
Humbeeksesteenweg, 98
1850 Grimbergen, Belgium
All Other Dealers
Handle the parts in accordance with your Warranty Bulletin on warranty parts handling.