Instruction Cards For "Go-No Go" Gauges Now Available{0653}
Usage:
During engine reconditioning procedures, "Go-No Go" gauges are used to see if some components can be used again. Each gauge is sent to the dealer with an instruction card. Separate replacement cards are now available if the original instruction card has been damaged or lost (Illustration 1-4). Each card fits inside the 5P4227 Tag Holder, which can be ordered separately. The four replacement cards which follow can now be ordered on a Miscellaneous Material Order form (01-019335-02).
Illustration 1.
Illustration 2.
Illustration 3.
Illustration 4.
Caterpillar Information System:
1981/05/18 New Mounting Group For Overspeed Switch{7410}
1981/05/18 Replacement Bushings For Delco-Remy Electric Starting Motors Must Be Machined For Correct Clearances{1453,1454,1465}
1981/05/18 Change Made To Power Take-Off Adapter Housing{3055}
1981/05/18 Remove Direct Injection Fuel Nozzles With 6V4061 And 6V4054 Nozzle Pullers{0621}
1981/05/18 Safety: Battery Vent Caps{1401}
1981/05/11 Installation Of Rear Bearing Oil Seals In 3N6542, 3N8617, And 3N8618 Rear Power Takeoff Clutch Groups{3055}
1981/05/11 Remove And Install Cam Bearings With 6V4077 Cam Bearing Tool Group{0621,0622}
1981/05/11 Caterpillar Cooling System Conditioner (Liquid Or Spin On Elements) Can Be Used In Ford Truck Installations{1350}
1981/05/11 Use 6V4069 Body Group To Remove Tapered Drive Sleeve{0611}
1981/05/04 Use 6V4057 Grease Gun Adapter In Difficult Access Areas{0671}
1981/05/04 Crankshaft Failures; New Thrust Plate{1203,1202,1230}
1981/05/04 Automatic Shut-Off Systems Not Recommended on Mobile Earthmoving Equipment{7418,7403}
1981/05/25 Use Correct Specifications To Check Piston Ring Gaps{1215}
1981/05/25 Washer Added Between Bolt And Thrust Plate For Oil Pump Idler Gear{1206}
1981/05/25 New Cover Assembly And Gasket Used In Oil Pump Group{7418}
1981/05/25 Air System Leakage Can Cause Problems With Engine Governor Stability At Low Idle RPM{1264,1803}
1981/06/01 Locks No Longer Used On Flywheel Bolts; New Torque Specifications For Flywheel Bolts{1156}
1981/06/01 Correct Use Of Keystone Ring Groove Gauges{1214,1215,1312,0653}
1981/06/01 New Seals And Clutch Discs Used{3300,3302}
1981/06/01 Some Single Part Numbers Have Two Half Bearings{7551}
1981/06/01 New Service Meter Used In Mechanical Shutoff Group{7478}
1981/06/01 Hardened Nuts And Higher Torque Now Used In Ahead And Astern Clutch Groups{3302}
1981/06/08 Inspect Piston Skirts During Engine Overhaul Procedures{1214,1213}
1981/06/08 Troubleshooting Water In Shut-Off Solenoid Housing{1259}