Power Module Lifting
The power module may need to be lifted by a crane from one position to another position. Two cranes are recommended in order to lift the power module. This will reduce unnecessary stress on the power module. The recommended height for the hook is 6 m (20 ft).
Show/hide table
 | |
| Illustration 1 | g00728446 |
Caterpillar Information System:
3412E, C30 and C32 Marine Engines Coolant Level Sensor Circuit - Test
3412E, C30 and C32 Marine Engines Indicator Lamp Circuit - Test
3412E, C30 and C32 Marine Engines Engine Sensor Open/Short Circuit - Test
3412E, C30 and C32 Marine Engines CAN Data Link Circuit - Test
3412E, C30 and C32 Marine Engines Aftercooler - Install
C4.4 (Mech) Industrial Engine Engine Lifting Bracket
C7 On-highway Engine Connecting Rod
3412E, C30 and C32 Marine Engines Digital Sensor Supply Circuit - Test
G3500 Generator Sets Model View Illustrations
3412E, C30 and C32 Marine Engines Analog Sensor Supply Circuit - Test
3412E, C30 and C32 Marine Engines Aftercooler - Remove
3412E, C30 and C32 Marine Engines Heat Exchanger - Install
PMG3516 Power Module Model View Illustrations
3056E Industrial Engine Main Bearing Journal
3054 and 3056 Marine Generator Set Engines Flywheel Housing
3412E, C30 and C32 Marine Engines Excessive White Smoke
3054 and 3056 Industrial and Generator Set Engines Coolant Temperature Switch
G3500H 60Hz Generator Sets Aftercooler Condensation - Drain
3054 and 3056 Marine Generator Set Engines Engine Oil Pressure Switch
C18 Generator set and C18 Marine Engines Heat Exchanger - Assemble - With Fuel Cooler
3412E, C30 and C32 Marine Engines Throttle Position Sensor Circuit - Test
3056E Industrial Engine Fuel Lines
3056E Industrial Engine Engine Oil Filter Base
Electronic Modular Control Panel II (EMCP II) Password Entry OP3