Installation Procedure
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Put O-ring (3) and fuel transfer pump (1) in position on the engine. Ensure that the rocker lever is positioned correctly on the camshaft lobe.
Illustration 1 | g00824616 |
Note: Ensure that the camshaft lobe for the fuel transfer pump is at minimum lobe lift before the fuel transfer pump is installed.
Note: The flange of the fuel transfer pump has two sets of locating holes. This allows the fuel transfer pump to be mounted in four positions.
- Install two bolts (4) that fasten fuel transfer pump (1) to the cylinder block.
- Connect the two fuel lines and hose clamps to the fuel transfer pump (1). Tighten the hose clamps.
- Prime the fuel system. Refer to Testing and Adjusting, "Fuel System - Prime" for additional information.