SPP101 Skid Mounted Pumper Caterpillar


Cooling System Water Temperature Regulator - Replace

Usage:

SPP101 715
在节温器出故障之前就应将其换掉。 这是推荐的预防性保养的做法。 更换节温器可减少可能发生的计划外停工。

节温器在部分开启位置失效时,会引起发动机过热或过冷。

水温调节器在完全关闭位置失效时,会引起发动机严重过热。 发动机严重过热会引起气缸盖开裂或活塞卡缸故障。

节温器在开启位置失效时,会引起发动机在部分负荷时工作温度过低。 发动机部分负荷时工作温度过低会造成气缸内积碳过多。 过多的积碳可能导致活塞环加剧和缸套的磨损。


注意

没有定期有计划的更换水温调节器可能会引起发动机严重损坏。

没安装水温调节器决不能运转发动机。

如果 温调节器安装不正确,发动机可能过热,造成气缸盖损坏。 确保新的水温调节器安装在原来的位置。


请参阅维修手册中有关节温器的更换步骤,或咨询您的卡特彼勒代理商。

注: 如果只更换水温调节器,排放冷却系统中的冷却液时,冷却液的液位只需低于水温调节器壳即可。 新水温调节器安装完毕之后,应向发动机加注冷却液至正确的液位。 确保使用正确类型的冷却液。 冷却液应始终保持在正确的浓度。

Caterpillar Information System:

Generator Set Control Panel for Switchgear Conversion Senders
Generator Set Control Panel for Switchgear Conversion Switches
Generator Set Control Panel for Switchgear Conversion Fuses
Generator Set Control Panel for Switchgear Conversion Quad Gauge Module
Generator Set Control Panel for Switchgear Conversion Main Display Module
3054 Engine for Caterpillar Built Machines Connecting Rod Bearings - Install
3500 and 3500B High Displacement Engines for Caterpillar Built Machines Belt Tightener - Remove
3054 Engine for Caterpillar Built Machines Pistons and Connecting Rods - Assemble
G3606 and G3608 Engines Engine Oil Coolers - Install
3054 Engine for Caterpillar Built Machines Pistons and Connecting Rods - Disassemble
3406E Truck Engine Boost Pressure Sensor
3408E and 3412E Engines for Caterpillar Built Machines Fuel Temperature Sensor
3512B and 3516B Engine Supplement for and 784C,, 785C and and 785C HAA Off-Highway Truck/Tractors Belt Tightener - Install
Generator Set Control Panel for Switchgear Conversion Sensors
3512B and 3516B Engine Supplement for and 784C,, 785C and and 785C HAA Off-Highway Truck/Tractors Belt Tightener - Disassemble
G3606 and G3608 Engines Engine Oil Coolers - Disassemble
3512B and 3516B Engine Supplement for and 784C,, 785C and and 785C HAA Off-Highway Truck/Tractors Belt Tightener - Assemble
3408E and 3412E Engines for Caterpillar Built Machines Unit Injector - Remove
G3606 and G3608 Engines Engine Oil Coolers - Assemble
Generator Set Control Panel for Switchgear Conversion Solenoids
G3606 and G3608 Engines Engine Oil Filter Housings - Remove
Generator Set Control Panel for Switchgear Conversion Operator Controls
3408E and 3412E Engines for Caterpillar Built Machines Unit Injector Hydraulic Pump Drive - Disassemble
G3408 and G3412 Engines Alternator and Regulator
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.