Note: Harness Code Mode 5 is only available on 155-8653 Engine Monitoring Control (Caterpillar Monitoring Systems) and newer Caterpillar Monitoring System modules.
Mode 5 Harness Code Display     | Application     |
03     | Generator Engine (1) with Standby Panel     |
05     | Generator Engine (1) With Prime Panel     |
06     | Generator Engine (1) With Premium Panel And "SCAC"     |
07     | Generator Engine With Premium Panel And JWAC "JWAC"     |
09     | Marine Propulsion Engine With Premium Panel And "SCAC"     |
10     | Marine Propulsion Engine With Prime Panel And Marine Gear Sensors     |
11     | Marine Propulsion Engine With Prime Panel And No Marine Gear Sensors     |
12     | Marine Propulsion Engine With Premium Panel And "JWAC"     |
35     | Locomotive Engine     |
( 1 ) | Includes Marine Auxiliary |
Note: If the selection for the harness code does not match the application, the Caterpillar Monitoring System may not operate correctly. The following list contains problems that the operator may encounter: the loss of event notification, incorrect data displays, incorrect gauge needle position and incorrect activation of diagnostic codes. CID 127 FMI 08, CID 177 FMI 08 and CID 819 FMI 02 are commonly caused by harness codes that are not correct for the application on new installations. Troubleshooting procedures are given for these diagnostic codes in the Testing And Adjusting Section of this Manual.
An example of Harness Code Mode (Mode 5) is provided below.
Illustration 1 | g00533697 |
Display Area |