PSP FOR INSTALLING NEW CLAMPS TO SECURE THE STARTER CABLES AND FUEL HOSE ON CERTAIN E70B EXCAVATORS Caterpillar

U-161
AU-104.1
1274, 1400  PS4515
NOTE: This Program can be administered either before or after a
failure. In either case the decision whether to apply the Program
is made by the dealer. When reporting the repair, use "PS4515"
as Part Number, "7755" as Group Number, and "96" as Description
Code.

August 31, 1991

New clamps can be installed to replace the existing clips that secure the
starter cable and fuel hose on certain E70B Excavators. The new clamps
better secure the hose and cable to extend their service life.

Model Identification Number
E70B 5TG1-174*
* 5TG172-174 do not require a new clamp for the starter cable.

4 - 961366 Clamp (Fuel Lines)
1 - 963938 Clamp (Starter Cable)

Remove the four existing fuel line clamps (2) and install four new 961366
Clamps. See Illustrations 1.
****** IMAGE: SEBE4373.00001.001
CAPTION: Illustration 1
On all Affected Product except 5TG172-174, remove the existing starter cable
clip (1) and install a new 963938 Clamp. See Illustrations 2.
****** IMAGE: SEBE4373.00001.002
CAPTION: Illustration 2

Product Caterpillar Dealer Suggested Customer Suggested
smu Parts Labor Hrs. Parts Labor Hrs. Parts Labor Hrs.
(D/N) (Cost)  (C/L) (Sell)
0-2000 100% 1.0 0 0 0 0
NOTE: This is a 1-hour job to install the new clamps for the fuel hose.
On Affected Product 5TG1-171, an additional .5 hour will be
allowed to install the clamp for the starter cable.

Any parts removed (with the exception of cores used for Caterpillar
Remanufactured parts) can be rendered useless and scrapped immediately upon
completion of the repair.