Generator Overcurrent - Troubleshoot
OK - If yes, go to Step 4.
NOT OK - If no, go to Step 3.
- The Rated voltage (V) equals the generator rated voltage
- The PT primary (V) equals the generator rated voltage
- The PT secondary (V) equals the generator rated voltage
Go to step 4.
OK - If winding inputs are ok, go to Step 5.
NOT OK - If winding inputs not ok, repair winding input fault. Check the system again.
STOP.
OK - If exciter resistance value is ok, go to Step 6.
NOT OK - If exciter resistance value is not ok, repair exciter fault. Check the system again.
STOP.
STOP.
Caterpillar Information System:
CP76 and CS76 Vibratory Compactors Propel System Pump Control (Manual Displacement Control) Neutral (Drum Propel) - Test and Adjust
3176C Engine for the R1600G and the R1700G Load Haul Dumps Acceleration Is Poor or Throttle Response Is Poor
CAESultra v3.2 Software Installation{7604, 7620} CAESultra v3.2 Software Installation{7604, 7620}
938H Wheel Loader and IT38H Integrated Toolcarrier Hydraulic System Pilot Oil Accumulator (Dead Engine, Lift Arm Lower) - Test and Charge
3176C Engine for Caterpillar Built Machines Electronic Service Tool Does Not Communicate
3176C Engine for Caterpillar Built Machines ECM - Replace
CP76 and CS76 Vibratory Compactors Propel System Piston Pump Neutral (Axle Propel Pump) - Adjust
2007/09/03 A new Fuel Heater Group is Available {1296}
CP54 and CS54 Vibratory Soil Compactors Machine Systems Air Cleaner
14M and 16M Motor Graders Machine Systems General Information - Autolube System, If Equipped
CP76 and CS76 Vibratory Compactors Propel System Piston Pump Neutral (Drum Propel Pump) - Adjust
2007/08/27 Precautions for Cylinder Liner Installation {1201, 1216}
3176C Engine for the R1600G and the R1700G Load Haul Dumps Coolant Temperature Is High
Supplemental Parts Information for the USN Seabee AP655C{1000, 7000} Supplemental Parts Information for the USN Seabee AP655C{1000, 7000}
3176C Engine for Caterpillar Built Machines ECM Does Not Communicate with Other Modules
CS56, CS64, CS74, CS76, CP56, CP64, CP74 and CP76 Vibratory Soil Compactors Engine and Machine Warm-Up
3176C, 3406E and 3456 Industrial Engines Engine Cranks but Does Not Start
CP76 and CS76 Vibratory Compactors Propel System Pump Control (Manual Displacement Control) Neutral (Axle Propel) - Test and Adjust
3176C Engine for the R1600G and the R1700G Load Haul Dumps Engine Misfires, Runs Rough or Is Unstable
CP76 and CS76 Vibratory Compactors Propel System Neutral Start Switch - Test and Adjust
3176C, 3406E and 3456 Industrial Engines Engine Shutdown Is Intermittent
CS54 and CP54 Vibratory Soil Compactors Hydraulic System Oil Level - Check
3176C Engine for the R1600G and the R1700G Load Haul Dumps Engine Top Speed Is Not Obtained
140M Motor Grader Engine Supplement Aftercooler - Install