Piston Cooling Orifices
Usage:
Remove And Install Piston Cooling Orifices
START BY:
a. remove crankshaft and gear
NOTE: The piston cooling orifices are installed in the No. 2 and 4 main bearing bosses in the cylinder block. See illustration B 18488X1 on Page 115. A replacement is necessary only if they are damaged. Normally it will only be necessary to be sure the orifices are clean.
1. Use a soft punch to remove four orifices (1) from the cylinder block.
2. Use tool (A) to install the orifices in main bearing bosses No. 2 and 4 until they are against the counterbore. Be sure the orifices are open after they are installed.
END BY:
a. install crankshaft and gear
Caterpillar Information System:
3204 Industrial Engines Crankshaft And Gear
3204 Industrial Engines Crankshaft Rear Seal And Wear Sleeve
3204 Industrial Engines Flywheel Housing
3204 Industrial Engines Flywheel
3204 Industrial Engines Crankshaft Main Bearings
3204 Industrial Engines Camshaft Bearings
3204 Industrial Engines Camshaft
3204 Industrial Engines Pistons And Connecting Rods
3204 Industrial Engines Connecting Rod Bearings
3204 Industrial Engines Oil Pump And Relief Valve
3204 Industrial Engines Timing Gears And Plate
3204 Industrial Engines Timing Gear Cover
CATERPILLAR 3161 GOVERNOR Systems Operation
CATERPILLAR 3161 GOVERNOR Testing & Adjusting
3500 SERIES ENGINES HYDRAMECHANICAL PROTECTIVE SYSTEM Shutoff Control Group Identification
3500 SERIES ENGINES HYDRAMECHANICAL PROTECTIVE SYSTEM Thermostatic Pilot Valve (4L7108)
3500 SERIES ENGINES HYDRAMECHANICAL PROTECTIVE SYSTEM Accessory (Shutoff) Drive Group
3500 SERIES ENGINES HYDRAMECHANICAL PROTECTIVE SYSTEM Shutoff Control Group
3500 SERIES ENGINES HYDRAMECHANICAL PROTECTIVE SYSTEM Air Intake Shutoff
3500 SERIES ENGINES HYDRAMECHANICAL PROTECTIVE SYSTEM Tachometer And Service Meter Drive
3500 SERIES ENGINES HYDRAMECHANICAL PROTECTIVE SYSTEM Remote Shutoff Valve Group
3500 SERIES ENGINES HYDRAMECHANICAL PROTECTIVE SYSTEM Electrical Switches
3500 SERIES ENGINES HYDRAMECHANICAL PROTECTIVE SYSTEM Systems Operation
3500 SERIES ENGINES HYDRAMECHANICAL PROTECTIVE SYSTEM Testing And Adjusting